Condenser Scale Cleaning Process

1. Select Da Yu cleaning fluid based on the equipment material. Add the cleaning fluid in a certain proportion to the cooling water system, start the cooling pump to circulate for several hours. The cleaning fluid circulates continuously, chemically dissolving and removing the sediment layer.

2. Utilize a single condenser cleaning or a multi-unit series and parallel cleaning setup. Connect a circulating pump and piping between the cleaning storage tank and the condenser to form a closed loop, allowing the cleaning fluid to continuously circulate. This process dissolves and removes deposits within a few hours.

3. Wash by immersion method. Mix Dayu Cleaning Company's cleaning fluid in a certain proportion and add it to the condenser for static soaking. Dayu Cleaning informs you to soften and dissolve the sediment, drain the cleaning fluid, and rinse with clean water.

The primary cause of scale formation is:

Calcium and magnesium ions in the cooling water crystallize and precipitate as salts when heated, adhering to the inner walls of the equipment's copper pipes; metallic oxide products from the system piping; slime caused by the proliferation of bacteria and algae, etc.

Physical Cleaning Method:

The physical cleaning method employs advanced domestic cleaning technology with high-pressure cleaning. The high-pressure cleaning technique is powered by the motor or diesel engine of the cleaning machine, with pressure output controlled manually for cleaning the tubes. During operation, the high-pressure hose is inserted into the condenser copper tubes, where it uses a high-speed rotating cleaning nozzle to remove dirt inside the tubes, followed by rinsing with clean water.

Advantages of Physical Cleaning: Eliminates the cost of Y-agent required for chemical cleaning; avoids issues with waste liquid discharge or disposal after chemical cleaning; less prone to corrosion of condenser copper tubes, and fast.