Steel-lined plastic chemical equipment and storage tanks are indispensable and important basic equipment in industries such as petrochemicals, grain and oil, food, fire protection, transportation, metallurgy, and more. They are always a vital part of our economic life.

Can't do without various sizes of corrosion-resistant storage tanks, chemical storage tanks; their crucial role in the national economic development is irreplaceable. The products are widely applicable in the chemical, biological, dye, metallurgy, and other industries.

Rare earths, machinery, electricity, electronics, environmental protection, textiles, brewing, food, aviation, water supply, and wastewater treatment industries.
Precautions for the use of steel-lined plastic chemical equipment:
1. When storing high-resistance organic solvents in anti-corrosion tanks (storage tanks), anti-static equipment should be installed.
2. Anti-corrosion storage tanks should prevent intense impacts and knocks on the equipment's body during the production process.
3. Full plastic flanges, being softer than steel plates, require users to inspect the sealing function of the storage tank equipment before use. A liquid test can be conducted to check for leaks. Storage tanks (vessels) for containing chemical liquids

First, test for leaks with water to prevent any loss.
4. The anti-corrosion storage tanks are at room temperature and pressure. The steel-plastic composite storage tanks are used at temperatures of -40℃ to 98℃, while the polyethylene full plastic storage tanks are used at temperatures of -40℃ to 60℃.
5. Tanks (Storage Tanks) should be clearly marked with the stored substances when containing chemicals. Nearby the tank placement, there should be a drainage trench and dilution equipment.
6. It is necessary to open the venting port for the equipment's filling and discharge to prevent damage due to pressure.
7. Equipment should be used in an environment far from the source of vibration and prevent contact with open flames.
8. If there are pipes with joints or flanges at the bottom of the tank, they must be perpendicular to the barrel wall. Soft connections should be used to prevent uneven expansion of the barrel wall from top to bottom after the liquid is filled, which may cause damage to the joints.

Causes leakage, and in severe cases, damages the joint and drum.
9. When the liquid inlet is high above the tank bottom, the inlet should bend towards the tank wall to allow the liquid to flow down along the wall, reducing the impact on the bottom.
10. Piping and accessories connected to the equipment should prevent their weight from directly acting on the equipment. During lifting, receiving points, manholes, etc., on the equipment must not be used as anchor points.
11. The receiver on the equipment should be fitted with anti-acid gaskets and sealed properly, and gaskets should be replaced in a timely manner.
12. Equipment installation, operation, and protection must comply with national regulations.