Steel-lined plastic chemical equipment and storage tanks are indispensable and essential basic equipment in industries such as petrochemical, food, grain and oil, fire protection, transportation, metallurgy, etc. In our economic life, they are always

Can't do without various sizes of anti-corrosion storage tanks, chemical storage tanks; their crucial role in the national economic development is irreplaceable. The products are widely applicable in chemical, biological, dye, metallurgy, and more.

Rare earths, machinery, electricity, electronics, environmental protection, textiles, brewing, food, aviation, water supply, and wastewater treatment industries.
Safety Precautions for Steel Lined Plastic Chemical Equipment:
1. Antistatic equipment should be installed for storage tanks containing high-resistance organic solvents.
2. Corrosion-resistant storage tanks should prevent intense impacts and bumps to the equipment body during the manufacturing process.
3. Full plastic flanges, being softer than steel plates, require users to inspect the sealing function of the storage tank equipment prior to use. A liquid test can be conducted to check for leaks. Storage tanks (vessels) for containing chemical liquids.

First, test for leaks with water to prevent any loss.
4. Corrosion-proof storage tanks are at normal temperature and pressure. The composite steel-plastic storage tanks are used at temperatures ranging from -40℃ to 98℃, while the fully plastic polyethylene storage tanks are used at temperatures from -40℃ to 60℃.
5. Tanks (storage tanks) must be clearly labeled with the stored chemicals. Nearby the tank location, there should be a drainage trench and dilution equipment.
6. It is necessary to open the venting port for equipment filling and discharge to prevent pressure damage to the equipment.
7. Equipment should be used in an environment far from the source of vibration and should be kept away from open flames.
8. If there are pipes with joints or flanges at the bottom of the storage tank, they must be vertical to the tank wall. Soft connections should be used to prevent uneven expansion of the tank wall from top to bottom after the tank is filled with liquid, which could damage the joints.

Causes leakage, and in severe cases, may damage the joints and drum body.
9. When the liquid inlet is high above the tank bottom, the inlet should bend towards the tank wall to allow the liquid to flow down the wall, reducing impact on the bottom.
10. Piping and accessories connected to the equipment should prevent their weight from directly acting on the equipment. During lifting, the receiving points, manholes, etc., on the equipment must not be used as anchoring points.
11. Choose acid-resistant gaskets for the equipment's seals and ensure they are properly sealed. Replace gaskets promptly.
12. Equipment installation, operation, and protection must comply with national regulations.