The Hot Cleaning Furnace is a new type of specialized equipment for cleaning paint return parts and fixtures on coating lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as in the motorcycle, bicycle, automobile, steel furniture, communication, and power transmission industries. It achieves standard performance levels. The equipment boasts excellent environmental protection features and high economic benefits. After inspection by the environmental protection department, the emissions of pollutants like SO2 and NO are only 1/10 of the national standard, and its operating cost is just 1/8 of that of paint strippers.
I. Product Application
1. Remove the continuously thickening coating from the spray fixtures and clamps without altering the mechanical properties of the fixtures.
2. Complete and thorough removal of any defective paint or powder coatings from metal components without any damage to the workpiece.
3. Clean the paint layer adhered to the filter mesh and fan impeller of the water curtain cabinet.
4. Clean and remove wiring, insulation, adhered organic matter from transformers, motors, printing rollers, and cables.
5. Clean and remove oils, grease, and other organic matter from parts such as the engine, crankshaft, housing, piston rings, etc.
Section 2: Specifications and Data
Cabinet: Heavy-duty steel plate structural steel, square and channel steel supports. Full-welded construction with sealed contact to prevent fuel loss due to leakage.
Floor: Hard refractory castable, 4"-5" (10-13cm) thick, reinforced with structural channel steel. Easy to remove ash.
Door: Equipped with snap-lock components and high-strength sealing strips. The door can open over 180 degrees, ensuring safety and reliability with ease of use and durability.
Explosion-proof: The unique gravity-sealed top automatically releases excessive pressure, then closes to prevent air from contacting combustible materials.
Adjacent Insulation: The furnace wall, roof, and door are covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket insulation, secured with stainless steel pins and stainless steel mesh plate gaskets, asbestos-free. Metal sleeves prevent mechanical injury to the operator from the insulating panels. Clean furnace insulation rating up to 2300F (1275°C).
Exhaust:natural gas(Gas pressure requirement: 5-8 KPa), or light diesel.
Power Supply: 220-250V, 50Hz, Single Phase, 5-10A
Water Supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/minute).
Normal Cycle: 3-5 hours (including cooling time), automatic control.
Normal Operating Temperature: 750-800°F (400-430°C)
Pollution Standards: Compliant with new environmental protection standards.
Safety and Health Standards: Compliant with the new OSHA standards. Meets NFPA 86 requirements.
Insurance Standards: Compliant with most national and local regulations.
Corrosion-Resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.
Combustion Chamber Protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or careless impacts.
Multiple models of trolleys: Various models of trolleys are available to meet your diverse load requirements (standard containers).
Gas Burner: Designed specifically for incinerators. Features include an excellent clog-free nozzle design, easy maintenance, and heavy-duty construction. The burner's automatic cooling system prevents nozzle damage.
