The Hot Clean Furnace is a new specialized cleaning equipment for removing coatings from returned parts and fixtures on painting lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as in the motorcycle, bicycle, automotive, steel furniture, communication, and power transmission and transformation sectors. Its comprehensive performance meets standard levels. The equipment not only boasts excellent environmental protection features but also offers significant economic benefits. After being inspected by environmental protection authorities, its emissions of SO2, NO, and other waste gases are only 1/10 of the national standard, and its operating cost is only 1/8 of paint strippers.
I. Product Application
Remove the continuously thickening coating from the spray fixtures and clamps without altering the mechanical properties of the fixtures.
2. Complete and thorough stripping of any不合格 paint or powder coating from the surface of metal components, without any damage to the workpiece.
3. Clean the paint layer adhered to the filter mesh and fan impeller of the water curtain cabinet.
4. Clean and remove winding and adhered organic matter from wires, cables, transformers, motors, and printing rollers.
5. Clean and remove grease, oil, and other organic substances from parts such as the engine, crankshaft, housing, piston rings, etc.
II. Specifications and Data
Cabinet: Heavy-duty steel plate steel structure, supported by square steel and channel steel. Full-welded construction with sealed contact to prevent fuel loss due to leakage.
Ground: Rigid refractory castable, 4"-5" (10-13cm) thick, reinforced with steel I-beams. Easy to clean off ash.
Door: Equipped with a snap-locking mechanism and high-strength sealing strips. The door can open over 180 degrees, ensuring safety, reliability, convenience, and durability.
Explosion-proof: A unique gravity-sealed top automatically releases excessive pressure, then closes to prevent air from contacting flammable materials.
Adjacent Insulation: The furnace wall, roof, and door are covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket insulation, secured with stainless steel pins and stainless steel mesh plates with locking washers, asbestos-free. Metal bushes prevent mechanical injury to operators from the heat insulation panels. Cleanable furnace insulation rating up to 2300F (1275°C).
Exhaust:natural gas(Gas pressure requirement: 5-8 KPa), or light diesel.
Power Supply: 220-250V, 50Hz, Single Phase, 5-10A
Water supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/minute).
Normal Cycle: 3-5 hours (including cooling time) with automatic control.
Normal Operating Temperature: 750-800°F (400-430°C)
Pollution Standards: Compliant with new environmental protection standards.
Safety and Health Standards: Compliant with the latest OSHA standards. Meets NFPA 86 requirements.
Insurance Standards: Compliant with most national and local regulations.
Corrosion-resistant vapor barrier: Prevents corrosive vapors from condensing in the furnace. Significantly extends the lifespan of the blast furnace.
Combustion chamber protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or careless collisions.
Multiple models of trolleys: Various models of trolleys are available to meet your diverse load requirements (standard boxes).
Gas Burner: Designed specifically for furnace use. Features include an excellent clog-free nozzle design, easy maintenance, and heavy-duty construction. The burner's automatic cooling system prevents nozzle damage.
