HYQ-103Ultraviolet flame detectors for gas and oil industrial burners' flame detection. These detectors are sensitive only to the infrared radiation from flames, provide temperature output, and have strong anti-interference capabilities.

One,Main Technical Parameters

1.Power Supply: 220V 50/60HZ

2.Red Flare Detection – Infrared sensors display temperature

3.Test Response Time ≤ 0.2 seconds

4.Spectral response range: approximately 2.2 um

5.Sensor and controller wiring ≤50 meters

6.Inspection ObjectGasoline, Fuel Gas

Part Two: Transducer
    1.Probe mounting hole Φ20, front end of the probe must be ventilated and cooled.

Section 3: The terminal wires are as shown in the figure.

1Line Voltage (220V)

 2Neutral wire (220V)

 10.11Modular terminal blocks are connected to probe cables. (Refer to the probe cable wiring diagram for wire numbers.)

 5.6.7Passive normally open, normally open output, (7 point as common terminal)

Four, Installation    

1.Probe Installation

HYQ-103Infrared FlameInspectSensor is a non-contact flameInspectMeter. Please align the probe with the flame during installation by the user.The temperature range for the probe use is80℃When using on burners or other high-temperature equipment, the detection channel in front of the probe must be ventilated and cooled. The diameter of the detection channel must not be less thanΦ20, the probe's installation thread is a 4-inch pipe thread.

This product's detection sensitivity range is 10 meters, (in the detection channel of)Φ20 in size), butInspectThe distance for measurement will increase with the intensity of the flame temperature and the widening of the detection channel, but it must not exceed 15 meters.

2.Adjustment

HYQ-103Infrared FlameInspectionThe meter has been calibrated at the factory.Tested, generally speaking, installation is sufficient for use.

Five, Notice

Variable-frequency drives offer unparalleled advantages in industrial production. However, due to the high-power diode rectification and high-power transistor inverter operations within these drives, high-order harmonic currents are generated in the input/output circuits, causing interference to the power supply system, load, and other nearby electrical equipment. This interference is particularly pronounced in high-precision instruments and computer control systems with stringent anti-interference requirements. Therefore, for power supplies near flame detectors with variable-frequency equipment, it is essential to install an isolation power supply at the flame detector's power input to prevent high-order harmonic currents from damaging or piercing the flame detector.

Six, Cautionary Notes;

    During installation, please contact us by phone at any time. Particularly during the module setup process, feel free to reach out to our technical team with any issues.