DDB Series Multi-point Grease Pump (10 MPa)

I. Overview

The DDB series multi-point dry oil pumps are suitable for multi-line dry oil centralized lubrication systems with low lubrication frequency, no more than 50 lubrication points, and a nominal pressure of 10MPa. These devices supply lubricating grease directly or via a single-line strip oil feeder to various lubrication points, particularly suitable for small single-machine equipment such as crushers, forging machines, dock cranes, and printing machines.

Section II: Technical Specifications

Section 3: Dimensions

DDB-10 Multi-point Dry Oil Pump DDB-18, DDB-36 Multi-point Dry Oil Pumps

Section 4: Model Marking Instructions

Section 5: Instructions for Use

The multi-point grease pump series should be installed in environments with suitable ambient temperatures, minimal dust, and ease of greasing, adjusting, inspecting, and maintaining.

2. Before using the DDB series multi-point grease pump, add HL-20 gear oil to the primary reduction box to the level indicated by the oil gauge.

3. Refueling the oil reservoir of the dry oil pump must be done using an SJB-D60 manual oil pump or a DJB-200 electric oil pump, adding oil through the reservoir's filling port. Note that it is strictly prohibited to start the motor when there is no lubricating grease in the reservoir.

4. Wire the motor according to the rotation direction indicated on the storage drum, and do not reverse the direction.

5. The fuel filler neck filter screen must have a precision of not less than 0.2mm and should be cleaned regularly.
6. Keep the dry oil pump clean at all times. Strictly prohibit removing the cover to replenish oil to prevent foreign matter from entering the pump, which may affect normal operation.