HB-P Series Electric Lube Pumps and Units (40MPa)

I. Terms of Use

The HB-P series electric lubrication pump is suitable for single or double-line dry (dilute) oil centralized lubrication systems with a large number of lubrication points, wide distribution, high oil supply frequency, and nominal pressure of 40 (20MPa). It serves as a lubricant supply device. It can also be equipped with a mobile trolley, rubber hose, oil gun, and cable to form a portable electric lubrication pump unit for use in single-machine equipment with low oil supply frequency, few lubrication points, large oil supply volume, and不便采用集中润滑. The storage tank is also equipped with an automatic oil level alarm device. With the corresponding electrical control box, it can achieve automatic control and system monitoring.

II. Technical Specifications

Utilize grease with a penetration not less than 220 (at 25°C, 150g) 1/10mm (NLGI 0#-3#) and a viscosity grade of N68 or higher.

Section 3: Model Description

Four: Dimensions

5. Usage Instructions

1. The lubrication pump should be vertically installed and securely fastened in an area accessible for maintenance and low in dust. Also, ensure the ambient temperature is suitable for the pump's operating temperature range of -20℃ to +65℃.

2. Install the pump as close to the center of the lubrication system as possible to minimize piping length, maintain the lowest pressure drop, and ensure the pump generates enough pressure to overcome the back pressure at the lubrication points.

3. The motor must rotate in a clockwise direction.

4. Clean lubricant must be used, as lubricants containing impurities are often the main cause of pump and system failures. To replenish lubricant in the oil reservoir, an electric oil pump must be used to add lubricant through the replenishment port of the electric lubricant pump. It's best to add some lubricating oil before the pump is filled with lubricant for the first time, as the oil flows well and fills all parts, which is beneficial for removing air. If certain lubrication areas cannot use lubricating oil, the pump must run until the lubricant without air reaches the end of the pipeline.

5. Prior to use, the pump must be filled with 50# mechanical oil to the oil level indicator as specified.

6. Pipelines, particularly those from the oiler to the lubrication points, as well as the bearings to be lubricated, should be pre-filled with lubricating oil before installation.

7. This series of electric grease pumps is designed for indoor installation. When used outdoors or in harsh environments, protective measures must be taken.

Section 6: Order Cautions

1. For the HB-P series electric lubrication belt trolley, the length of the rubber hose and cable must be specified in the contract. If not specified, the supply will be based on a rubber hose length of 5 meters.

2. Any special requirements or instructions from customers should be noted in the contract, and our company will handle the design and manufacturing on behalf.