One,Akron Abrasion Tester Manufacturer / Akron Abrasion TesterKey Technical Specifications
 

The applied force on the rubber wheel is: 26.7N (2.7kgf)
 

The rotation speed of the solid rubber wheel shaft is: 76 ± 2 rpm.
 

3 Sanding wheel shaft rotation speed: 3 3—3 5 r/min
 

The adjustable angle range for the solid tire axle and the grinding wheel axle is: 0°-4.5°
 

5 Power Voltage: AC220±10%V
 

6 Dimensions (Length x Width x Height): 600 x 480 x 400mm
 

Net Weight: 60 kg
 

　　8. Attachment: Electronic Counter 1 Unit
 

Section Two:Akron Abrasion Machine Manufacturer / Akron Abrasion MachineMaintain and service
 

1. Before use, check that all moving parts are functioning normally in terms of transmission and rotation. When not fitted with weights (but the weight shaft and retainer must be placed on the abrasive wheel bracket), the abrasive wheel should be in a vertical position.
 

2. The tilt angle of the tire shaft and the pressure exerted by the grinding wheel on the sample are important factors affecting the test results, and should be calibrated regularly.
 

Adjust the base of the testing machine to a level position during calibration.
 

4 The force exerted on the rubber wheel should be measured as 26.7N using a weight or an equivalent force measuring device.
 

5 Adjust the angle with the adjustment bolt, usingAkron Abrasion MachineThe angle gauge measures the angle between the rubber wheel shaft and the abrasive wheel shaft, with an adjustable range of 0° to 45°.