Acid-resistant liquid ceramic distributor for interior componentsAn eight-hole design with inner diameters of 80mm is set in the middle, with the lower end of the holes flush with the distributor body and the upper end slightly below. Surrounding the ventilation holes, there are 26 evenly spaced convection holes within the distributor body, with inner diameters of 38mm. The lower ends of the convection holes are flush with the distributor body, while the upper ends are lower than the height of the ventilation holes.Two overflow ports are set at the top of each convection hole, with the height of the overflow ports not exceeding one-third of the convection hole height. The lower end of the overflow ports is 30mm from the bottom surface of the distributor cavity. Ring-shaped flow-control grooves are set on the lower surface of the distributor around each convection hole.

Acid-resistant liquid ceramic distributor for internal componentsThe flow restrictor cross-section is arc-shaped with a depth of 5mm. When the distributor is in an inclined position, the liquid can accumulate in the flow restrictor without intermingling on the bottom surface of the distributor. The number of vent holes and flow holes, the diameter and distribution position of the internal holes, as well as the size and shape of the overflow port, are determined based on the size of the distributor body.