FT-8400 Series Automatic Insulation Resistance and Dielectric Constant Tester

Overview:

Insulation powder resistivity tester analyzes the resistivity of insulation powder under different pressures/Under pressure, the trend of electrical insulation performance of the powder under different porosity states.Thus, to evaluate the powder for reference in actual production, research and development, and quality provision..

AdoptPCSoftware operation, graphical charts showing the change in particle cohesion and deformation or recovery processes before and after powder compression, due to the inherent properties of the powder; automatic test process data curves and chart analysis, real-time analysis of pressure/Pressure and resistance, resistivity, and conductivity variations, as well as report generation, storage, and printing.

Load units with optional range settings, direct reading of powder compression displacement values, display resistance, resistivity, pressure values, automatic unit conversion.

Two.Application Scope:

FT-8400 Series Automatic Insulation Powder Resistivity Tester, Automatic Voltage Insulation Resistance Meter

Application: Measurement and analysis of insulating powder particles with similar properties such as plastic powder, coatings, resin powder, chemical powder, rubber powder, etc..

Also suitable for measuring electrostatic analysis due to the change in cohesion of insulating powder during the compression process..

Specification ModelFT-8400AFT-8400B

Resistor Range10^4Ω～1×10^13Ω10^4Ω ～1×10^16Ω

2. Resistance range10^4Ω～1×10^13Ω-cm10^4 ～ 2.0×10^16 Ω-m

3. Test Voltage0-1000V 

4. Resistance Accuracy1G ±1%; ≥1G ±3%; ≥1T ±10%; ≥10T ±20% (standard resistors)

5. PC Software Interface

Resistors, resistivity, unit conversion, current, voltage, thickness, graph display, pressure setting, pressure, report export, waveform refresh, time setting, start, stop, operation

Compacted Density

FT-8400 Series Automatic Insulating Powder Resistivity Tester, Automatic Voltage Insulation Resistance Meter

6. Test MethodsThe testing powder is conducted using the two-electrode method (the three-loop electrode method can be used for solid materials).

7. MoldsStandard mold inner diameter: 10mm; other specifications available for customization.

8. Pressure Range Selection:a.200kg；   b.300kg；   c.500kg；   d.1000kg

9. Mold Travel0-20mm

10. Sample Height

Automatic real-time sample height range to the thousandths: 0.001-10.000mm, measurement resolution 0.001mm, capable of measuring sample compression thickness of 0.1mm

11. Constant Pressure Time:0-99.9s

12. Temperature and humidity rangeRoom temperature -50°C; Humidity: 20%-98%

13. Standard Componentsa. Standard Calibration Resistor 1 pc.; b. Standard Height Calibration Part 1 pc.

14. Testing Methoda. Automatic Measurement b. PC Software Interface Operation

15. Pressure MethodAutomated Operation

16. Molding methodAutomatic Operation

17. Electrode MaterialCopper Electrode

18. Vacuuming SystemExternal Vacuum Processor

19. Tolerance:1%-15% varies due to material characteristics and range error.

20. Working Power Supply:AC 220V±10%, 50Hz: 60W

21. Standard Equipment, Optional Accessoriesa. Computers and printers are configured according to customer requirements; b. 1计量 certificate provided

c. Moisture Meter d. True Density Meter