The Hot-Cleaning Furnace is a new specialized equipment for cleaning coatings off returned workpieces and fixtures on painting lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as motorcycles, bicycles, cars, steel furniture, telecommunications, and power transmission and transformation. Its comprehensive performance meets standard levels. The equipment not only boasts excellent environmental performance but also offers high economic benefits. Environmental protection department tests show that the emissions of SO2 and NO are only 1/10 of the national standard, and its operating cost is merely 1/8 of paint strippers.
I. Product Application
1. Remove the continuously thickening coating from the spraying fixtures and clamps without altering the mechanical properties of the fixtures.
2. Complete and thorough stripping of non-compliant paint or powder coating from the surface of metal components, with no damage to the workpiece.
3. Clean the paint layer adhered to the filter mesh and fan blades of the water curtain cabinet.
4. Clean and remove winding and adhered organic matter from wires, cables, transformers, motors, and printing rollers.
5. Clean and remove grease, oil stains, and other organic substances from engine parts such as the crankshaft, housing, piston rings, etc.
II. Specifications and Data
Cabinet: Heavy-duty steel structural frame with square and channel steel supports. Full welded construction and sealed contact to prevent fuel loss due to leakage.
Floor: Hard refractory castable, 4"-5" (10-13cm) thick, reinforced with steel structural channels. Easy to remove ash.
Door: Equipped with snap-lock components and high-strength sealing strips. The door can open over 180 degrees, ensuring safety and reliability with ease of use and durability.
Explosion-proof: Unique gravity-sealed top automatically releases excess pressure, then closes to prevent air from contacting flammable materials.
Adjacent Insulation: The furnace wall, roof, and door are covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket insulation, secured with stainless steel pins and stainless steel mesh plate gaskets, asbestos-free. Metal sleeves prevent mechanical injury to operators from the heat-insulating panels. Clean furnace insulation rating up to 2300F (1275°C).
Exhaust:natural gas(Gas pressure requirement: 5-8 KPa), or light diesel.
Power Supply: 220-250V, 50Hz, Single-phase, 5-10A
Water Supply: Minimum pressure 40psi, maximum pressure 100psi. Minimum flow rate 5gpm (15 gallons per minute).
Normal Cycle: 3-5 hours (including cooling time), automatically controlled.
Normal Cycle Temperature: 750-800°F (400-430°C)
Pollution Standards: Compliant with new environmental protection standards.
Safety and Health Standards: Compliant with the new OSHA standards. Meets NFPA 86 requirements.
Insurance Standards: Compliant with most national and local regulations.
Corrosion-resistant vapor barrier: Prevents corrosive vapor condensation in the furnace. Significantly extends the service life of the blast furnace.
Combustion Chamber Protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or negligent collisions.
Multiple model trolleys: Various models of trolleys meet your diverse load requirements (standard containers).
Gas Burner: Designed specifically for incinerators. Features include an excellent clog-free nozzle design, easy maintenance, and heavy-duty construction. The burner's automatic cooling system prevents nozzle damage.
