The Hot Cleaning Furnace is a new type of specialized equipment for cleaning paint return parts and fixtures on coating lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as in the motorcycle, bicycle, automobile, steel furniture, communication, and power transmission industries. Its comprehensive performance meets standard levels. The equipment not only boasts excellent environmental protection features but also offers significant economic benefits. After being tested by the environmental protection department, the emissions of pollutants like SO2 and NO are only 1/10 of the national standard, and its operating cost is just 1/8 of that of paint strippers.
I. Product Application
Remove the continuously thickening coating from the spray fixtures and clamps without altering the mechanical properties of the fixtures.
2. Complete and thorough stripping of不合格 paint or powder coating from the surface of metal components, with no damage to the workpiece.
3. Clean the paint adhered to the filter mesh and fan blades of the water curtain cabinet.
4. Clean and remove winding and adhered organic matter from wires, cables, transformers, motors, and printing rollers.
5. Clean and remove grease, oil stains, and other organic substances from engine parts such as the crankshaft, housing, piston rings, etc.
Part II: Specifications and Data
Cabinet: Heavy-duty steel plate steel structure, supported by square and channel steel. Full welded construction and sealed contact prevent fuel loss due to leakage.
Ground: Rigid refractory castable, 4"-5" (10-13cm) thick, reinforced with steel structural channels. Easy to remove ash.
Door: Equipped with a snap-lock component and high-strength sealing strips. The door can open over 180 degrees, offering safety, reliability, convenience, and durability.
Explosion-proof: The unique gravity-sealed top automatically releases excessive pressure, then closes to prevent air from contacting flammable materials.
Adjacent Insulation: The furnace wall, roof, and door are covered with 2-3 layers of lightweight ceramic fiber blanket (10-15cm thick) for insulation. These are secured with stainless steel pins, stainless steel mesh plates, and lock washers, free of asbestos. Metal sleeves prevent mechanical injury to the operator from the insulation panels. Clean炉insulation rating: 2300°F (1275°C).
Exhaust:natural gas(Gas pressure requirement: 5-8 KPa), or light diesel.
Power Supply: 220-250V, 50Hz, Single Phase, 5-10A
Water supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/minute).
Normal Cycle: 3-5 hours (including cooling time) with automatic control.
Normal Cycle Temperature: 750-800°F (400-430°C)
Pollution Standards: Compliant with new environmental protection standards.
Safety and Health Standards: Compliant with the new OSHA standards. Meets NFPA 86 requirements.
Insurance Standards: Compliant with most national and local regulations.
Corrosion-resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.
Combustion chamber protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or negligent collisions.
Multiple model carts: A variety of different cart models can meet your various load requirements (standard containers).
Gas Burner: Designed specifically for furnace use. Features include an excellent clog-free nozzle design, easy maintenance, and heavy-duty construction. The burner's automatic cooling system prevents nozzle damage.
