The Hot-Cleaning Furnace is a new specialized cleaning equipment designed for removing coatings from returned parts and fixtures on painting lines, widely used in industries such as air conditioners, refrigerators, microwaves, electric fans, computers, and home appliances, as well as motorcycles, bicycles, cars, steel furniture, telecommunications, and power transmission and transformation. It boasts comprehensive performance that meets standard levels. Not only does it have excellent environmental protection features, but it also offers significant economic benefits. After being tested by the environmental protection department, the emissions of SO2, NO, and other waste gases are only 1/10 of the national standard, and its operating cost is only 1/8 of that of paint strippers.
I. Product Applications
1. Remove the continuously thickening coating from the spray fixtures and clamps without altering the mechanical properties of the fixtures.
2. Complete and thorough stripping of non-conforming paint or powder coatings from the surface of metal parts, without any damage to the workpieces.
3. Clean the paint layer adhered to the filter mesh and fan blades of the water curtain cabinet.
4. Clean and remove insulation, adhered organic matter, and winding from wires, cables, transformers, motors, and printing rollers.
5. Clean and remove grease, oil stains, and other organic substances from parts such as the engine, crankshaft, housing, piston rings, etc.
II. Specifications and Data
Cabinet: Heavy-duty steel plate steel structure, supported by square and channel steel. Full welded construction and sealed contact prevent fuel loss due to leakage.
Floor: Rigid refractory castable, 4"-5" (10-13cm) thick, reinforced with steel structural channels for ease of ash removal.
Door: Equipped with a snap-locking component and high-strength sealing strips. The door can open over 180 degrees, ensuring safety and reliability with ease of use and durability.
Explosion-proof: Unique gravity-sealed top automatically releases excess pressure, then closes to prevent air from contacting flammable materials.
Adjacent Insulation: The furnace wall, roof, and door are covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket insulation, secured with stainless steel pins, stainless steel mesh plates, and lock washers, free of asbestos. Metal sleeves prevent mechanical injury to operators from the heat-insulating panels. Clean furnace insulation rating up to 2300F (1275°C).
Exhaust:natural gas(Gas pressure requirement: 5-8KPa), or light diesel.
Power Supply: 220-250V, 50Hz, Single Phase, 5-10A
Water supply: Minimum pressure 40psi, maximum pressure 100psi. Minimum flow rate 5 gpm (15 liters/min).
Normal Cycle: 3-5 hours (including cooling time) with automatic control.
Normal Cycle Temperature: 750-800°F (400-430°C)
Pollution Standards: Compliant with new environmental protection standards.
Safety and Health Standards: Complies with the new OSHA standards. Meets N.F.P.A. 86 requirements.
Insurance Standards: Compliant with most national and local regulations.
Corrosion-Resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.
Combustion chamber protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or careless collisions.
Multiple model trolleys: Various models of trolleys can meet your diverse load requirements (standard containers).
Gas Burner: Designed specifically for furnace use. Features include an advanced clog-free nozzle design, easy maintenance, and heavy-duty construction. The burner's automatic cooling system prevents nozzle damage.
