The Hot Clean Furnace is a new type of specialized equipment for cleaning paint return parts and fixtures on coating lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as in the motorcycle, bicycle, automotive, steel furniture, communication, and power transmission industries. It achieves a comprehensive performance that meets standard levels. The equipment not only boasts excellent environmental protection features but also offers significant economic benefits. After inspection by the environmental protection department, the emissions of pollutants like SO2 and NO are only 1/10 of the national standard, and its operating cost is merely 1/8 of that of paint strippers.
I. Product Application
1. Remove continuously thickening coatings from spray fixtures and clamps without altering the mechanical properties of the fixtures.
2. Complete and thorough stripping of the不合格 paint or powder coating from the surface of metal parts, with no damage to the workpiece.
3. Clean the paint adhered to the filter mesh and fan blades of the water curtain cabinet.
4. Clean and remove wiring, insulation, transformer winding, motor winding, and adhered organic matter from wires, cables, transformers, motors, and printing rollers.
5. Clean and remove grease, oil stains, and other organic matter from engine parts such as the crankshaft, housing, piston rings, etc.
II. Specifications and Data
Cabinet: Heavy-duty steel structural frame with square steel and channel steel supports. Full welded construction with sealed contacts to prevent fuel loss due to leakage.
Ground: Rigid refractory castable, 4"-5" (10-13cm) thick, reinforced with structural steel channel beams. Easy to remove ash.
Door: Equipped with a snap-locking mechanism and high-strength sealing strips. The door can open over 180 degrees, ensuring safety, reliability, ease of use, and durability.
Explosion-proof: The unique gravity-sealed top automatically vents excess pressure, then closes, preventing air from contacting combustible materials.
Adjacent Insulation: The furnace wall, roof, and door are covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket insulation, secured with stainless steel pins and stainless steel mesh plates with locking washers, free of asbestos. Metal bushes prevent mechanical injury to operators from the insulating panels. Clean furnace insulation rating of 2300F (1275°C).
Exhaust:natural gas(Gas pressure requirement: 5-8KPa), or light diesel.
Power Supply: 220-250V, 50Hz, Single Phase, 5-10A
Water Supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/minute).
Normal Cycle: 3-5 hours (including cooling time), automatically controlled.
Normal Cycle Temperature: 750-800°F (400-430°C)
Pollution Standards: Compliant with new environmental protection standards.
Safety and Health Standards: Compliant with new OSHA standards. Meets NFPA 86 requirements.
Insurance Standards: Compliant with most national and local regulations.
Corrosion-Resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.
Combustion Chamber Protection: Heavy-duty steel guards are installed around the upper and lower combustion chambers to prevent accidental or careless collisions.
Multiple model trolleys: Several different models of trolleys are available to meet your various load requirements (standard containers).
Gas Burner: Designed specifically for incinerators. Features include an excellent non-clogging nozzle design, easy maintenance, and heavy-duty construction. The automatic cooling system of the burner equipment suppresses nozzle damage.
