The fully automatic integrated distillation unit is a new intelligent distillation processing device that integrates constant-temperature heating, automatic control of distillation endpoint, and cooling water circulation according to the laboratory distillation pretreatment operation procedures. It is widely applicable in various chemical laboratories requiring distillation processing, such as environmental protection, disease control, aquaculture, water supply and drainage, universities, research institutions, factories, and mines, for distillation processes of volatile substances, ammonia nitrogen, Kjeldahl nitrogen oil moisture, and other projects; as well as distillation operations in food testing for residual amounts and formaldehyde, alcohol content, etc.

Key Features:

1. Utilize far-infrared ceramic heating elements instead of high-power electric heaters, while incorporating intelligent distillation endpoint control.

2. Available in two modes: quantitative weighing and timer modes, with manual supervision required.

3. 7-inch large LCD touch screen control, one-touch operation, simple and convenient to use

4. Features include precise temperature control, automatic anti-siphon, even heating, anti-boil-over, and intelligent endpoint control.

5. Easy to operate, automatic distillation, aesthetically pleasing and practical, energy-saving, and environmentally friendly.

6. Process up to 6 sets of samples at once, featuring single-hole temperature control with imported temperature sensors. Digital temperature display offers clear and easy-to-read data.

7. Cooling Method: Closed-loop internal recirculation system; for higher requirements of circulating water temperature, other circulating water devices can also be externally connected.

The installation sequence of the fully automatic distillation unit is from bottom to top, and from left to right. Ensure that the part of the distillation unit is closer to the water tank, i.e., near the water tank. The axis of the entire unit should be on a single plane, and this plane should be parallel to the edge of the experimental table.
Before installing the fully automatic integrated distillation unit, inspect the installation surface, power supply, and installation space to ensure the surface is secure, the voltage is stable, and the space is adequate.
Detailed installation steps for integrated distillation equipment:
Install beam, glassware; according to the drawings, secure the beam, condenser bracket, condenser, and distillation flask to the instrument, and then connect the recirculating water pipes.
2. Power on the instrument and connect the power plug to the main power source and the auxiliary power source separately.
3. Fill the cooling water, place one side of the silicone tube in the sink (do not directly connect to the water tap), and connect the other side to the instrument's water inlet. Then, turn on the main switch, press the water filling switch on the display screen. The water tank will start filling. Observe the liquid level height through the liquid level window on the front left of the instrument. Close the water filling switch on the water tank when the liquid level reaches the desired position.
An integrated distillation unit is a novel intelligent distillation processing device that combines constant-temperature heating, automatic distillation endpoint control, and cooling water circulation according to the laboratory distillation pretreatment operation procedures. The instrument features precise temperature control, automatic anti-back-siphon protection, uniform heating, anti-boil-over, and intelligent endpoint control. It is easy to use, energy-saving, and environmentally friendly.