How to perform IEC62384 testing

Introduction to IEC62384 Testing

What is LCP testing? Where in Shenzhen can I find a lab to issue an LCP test report? What is the IEC 62384 standard? How much does it cost to perform an LCP test? Which lab is the most affordable?

How to obtain the Australian LCP certification? Where can I get IEC/EN62384 certification done?

LCP certification, short for Lamp Circuit Power, primarily tests the performance of LED modules.

The standard adopted is IEC 62384.

Testing includes:

Output Voltage, Current

2: Total Line Power

Line Power Factor

Four: Input Current

Five: Exception

Six: Durability

What is LCP testing? What are the contents of IEC 62384 testing?

　　LCPLamp Circuit Power is the combined power consumption of alampand its controlgear.

LED Module AC/DC Power Electronic Control Device - Performance Requirements

　　DCor AC supplied electronic control gear for LED module–Performance

　　requirements

1. Scope

This standard specifies direct current below 250V and frequencies of 50Hz/60Hz (the output frequency may differ from the supply frequency).

AC power supply below 1,000V, paired with LED modules compliant with IEC 62031

Performance requirements for the control device of the LED module. The control device for the LED module specified in this standard is designed to supply a fixed voltage or

Fixed current. This standard also applies to non-pure fixed voltage and fixed current types.

Note 1. The tests in this standard are type tests and do not include tests for individual control devices during the production process.

Seeking.

2. Control requirements for devices with varying output power are still under consideration.

3. Control devices compliant with this standard, as specified by the manufacturer, can ensure operation within the rated range of 92% to 106%.

Operate under reduced voltage.

2. Necessary Reference Materials

Use of this standard should be accompanied by the following referenced standards. Referenced standards marked with a date apply only to the current edition. Unmarked

Dates applicable to the new version (including all additions and revisions).

　　IEC61347-2-13, Lamp controlgear – Part 2-13:Particularrequirements for d.c. or a.c.

　　suppliedelectronic gear for LED modules

　　IEC62031, LED modules for general lighting –Safetyrequirements

3. Terms Explanation

This standard applies to the following definitions of terms.

3.1 Total Circuit Power

Under the rated voltage of the control unit and high rated output load, the combination of the LED module and the control unit...

Test Items:

I. Input Current (constant current power supply), Criteria: 10% of rated value

II. Voltage: (Rated Voltage), Criteria: -10%

III. Total Power, Criteria: 10%

IV. Power Factor, Error <= -0.05