304 stainless steel camelback support plateThis support plate is made by punching many long oval holes into 3-4mm thick stainless steel plates, forming the plate, then welding it to a flat steel ring. The number and spacing of the waves are determined specifically according to the tower diameter. This plate provides a free cross-section, has good bearing capacity due to its wave structure, and a high porosity, making it suitable for towers with a diameter of 1200mm or less.
304 stainless steel camelback support plateExcellent fluid dynamics performance; separate gas-liquid flow channels; the gas phase is ejected into the packing layer through side holes in the support plate, while the liquid phase flows downward through bottom holes in the support plate, ensuring unobstructed and uniform gas-liquid flow and preventing intermixing between gas and liquid; allowing a large gas-liquid throughput.































