Solar PV U-shaped and C-shaped bracket production equipment

　　Molding Production Line Process:Coil Unwinding & Opening----Leveling & Feeding Integrated Machine----Molding Main Unit (Gear Rolling, Marking)---Straightening Device----Cutting System----Receiving Platform---Electrical Control with PLC Programmable Logic Controller

　　Automatic Punching Line ProcessWorkbench - Pneumatic Clamps, Servo Feeding Units ---- Hydraulic (Press) Punching

Electrical control uses PLC programmable logic control

Punching method: Depending on the actual situation and considering various factors, post-molding is adopted.

Customizable into a one-step punching and forming production line

Equipment Technical Requirements

　　1. Technical Equipment Conditions:

1.1 Equipment Footprint: 25×3.5×5 (Length×Width×Height) meters.

1.2 Equipment Material Direction: TBA.

1.3 Voltage Parameters: 380V, 50Hz, 3-phase.

1.4 Gas Source: Flow rate of 0.5 m³/min; pressure of 0.6 MPa.

1.5 Hydraulic Oil: 46# Hydraulic Oil.

1.6 Gear Oil: 18# Hypoid Gear Oil.

　　2 Main Technical Parameters of Equipment

2.1 Rolling Strip Width: ≤300 mm

2.2 Rolling Strip Thickness: 2.0~2.5 mm

2.3 Rolling Strip Material: Q235

2.4 Production Speed: Approximately 0-14 meters per minute across the entire line

2.4 Rolling workpiece length: 2000-6000 mm

2.5 Total installed equipment capacity: approximately 35KW.

　　3. Rolling Product Range

3.1 This stamping/molding unit can roll U-shaped sections with a thickness of 2.0~2.5mm.

3.2 Rolling Product Specifications and Dimensions