Solar PV U & C Bracket Production Equipment

　　Molding line:Coil Unwinding & Opening ---- Leveling & Feeding Integrated Machine ---- Molding Main Unit (Gear Rolling, Marking) --- Calibration Device --- Cutting System --- Collection Platform ---- Electric Control with PLC Programmable Logic Control

Punching line: workbench - pneumatic clamps, servo feeding unit - hydraulic (punch press) punching

Electrical control utilizes PLC programmable logic control

Hole punching method: After forming, based on actual conditions and considering various factors.

Customizable into a one-step punching and forming production line

Equipment Technical Requirements

　　Equipment Technical Conditions:

1.1 Equipment Footprint: 25×3.5×5 (Length×Width×Height) meters.

1.2 Equipment Feed Direction: TBA.

1.3 Voltage parameters: 380V, 50Hz, 3-phase.

1.4 Gas Source: Flow rate of 0.5 m³/min; pressure of 0.6 MPa.

1.5 Hydraulic Oil: 46# Hydraulic Oil.

1.6 Gear Oil: 18# Hyperbolic Gear Oil

　　2 Main Technical Parameters of Equipment

2.1 Rolling Strip Width: ≤300 mm

2.2 Rolling Strip Thickness: 2.0~2.5 mm

2.3 Rolling Strip Material: Q235

2.4 Production Speed: Approximately 0-14 meters per minute across the entire line

2.4 Rolling workpiece length: 2000-6000 mm

2.5 Total installed capacity of equipment: approximately 35 kW.

　　3. Rolling Products Range

3.1 This stamping/molding unit is capable of rolling U-shaped sections with a thickness of 2.0~2.5mm.

3.2 Rolling Product Specifications and Dimensions

Manufacturing equipment according to profile drawings and actual requirements!

Hotline for inquiries:138-6182-8986 (WeChat sync)