FT-106A Micron Powder Accumulation Density Tester - Vibration Funnel Method

Refer to Standardsstandard：

ISO9136-2：1999（EAbrasive--Measurement of Bulk Density--Micro-fine powder

Operating Principle: The micro-powder to be tested is poured into a funnel, where it remains in a stacked state due to its own weight. Once the electromagnetic oscillator is activated, the micro-powder is subjected to electromagnetic vibration, flowing into the measuring bucket. The micro-powder that falls into the measuring cylinder is then leveled. The mass of the leveled micro-powder in the measuring cylinder is weighed on a balance, and then divided by the volume of the measuring cylinder to determine the bulk density of the micro-powder.

II. Technical SpecificationsParameters：

Funnel Material: Stainless Steel

Funnel Size: Height290mmOutside Diameter190mmOuter Diameter of Discharge Port:28mmDischarge height:38mm

Vibration槽 material: Stainless steel

Vibration trough size:210mm×40mm×30mm）±1mm

Measuring Tube Size: Internal Diameter64mmInterior height62.2mm

Volume of measuring cylinder: (200±0.5) cm3

Measuring cylinder volume: (200±0.5) cm3

Measurement Error:≤±0.02g/cm3

Funnel bottom inner diameter:28mmBeaker capacity:200ml ; Funnel discharge height:38mmTested micro-powder falling height:140mm.

FT-106A Micron Powder Accumulation Density Tester, Vibration Funnel Method