
Cutting of PC Sunshine Board:
Sunlight boards can be cut with a sharp utility knife, while endurance boards can be cut with a hand saw. When cutting, the board should be fixed to avoid tearing caused by severe vibration.
Installation of PC Sunshine Board:
During installation, the side of the PC board with anti UV markings must face outward.
Before installation, all empty ends of the solar panel should be sealed with aluminum sealing tape.
During the installation process, construction personnel are not allowed to stand directly on the PC board for construction.
After the construction is completed, the debris on the PC board should be cleaned up.
Cleaning and maintenance of PC polycarbonate panel:
Regular cleaning with the correct method and appropriate tools can extend the service life of PC boards.
Small area cleaning:
Rinse with warm water;
Rinse with neutral soap or household detergent mixed with warm water, and use a soft fabric or sponge to remove dust and dirt;
The water additives should be compatible with the PC board.































