Composition   This product is a two-component self-curing paint composed of a resin base, with added pigments, citrus rheology additives, fillers, solvents, etc.

Performance   The hammer-textured paint offers excellent decorative performance with an aesthetically pleasing dimpled orange peel finish. The coating boasts good decorative effects, high hardness, and excellent wear resistance, as well as good oil and chemical corrosion resistance.

Usage   Widely used for the coating of iron and plastic products such as machine tools, interior walls of wagons, outdoor bus shelters, machinery and equipment, electrical cabinets, etc.

Product Specifications

Film color: Customer specified

Mix Ratio: Base Paint: Hardener = 20:5

Technical Specifications

Comprehensive system

Primer: Epoxy primer, zinc-rich primer.

Interior and exterior universal paint: Orange grain finish

Construction Method

1. Base Material Processing

The coated metal surface must be thoroughly cleaned of oil, rust scale, corrosion, old coatings, etc. Shot blasting or sandblasting methods can be used to achieve the Swedish rust removal standard Sa2.5, with a roughness of 30-70μm. Alternatively, manual rust removal can be employed to meet the Swedish rust removal standard St3, with a roughness of 30-70μm.

2. Mixed

Priced by weight ratio (as indicated on the product packaging)

While mixing, slowly pour the hardener into the main agent while continuously stirring, ensuring thorough and even mixing.

After the mixed paint has matured (at 23±2℃) for 30 minutes, filter it through a 60-80 mesh sieve and pour it into another container for later use.

Mixed paint has a shelf life of 3 hours, please schedule usage according to the progress of the job.

3. Construction Conditions

The coating operation should be carried out as soon as possible after the substrate treatment, generally not exceeding 6 hours. The surface temperature of the substrate and the ambient temperature should generally not be below 10°C, with the surface temperature at least 5°C higher than the dew point, and the relative humidity of the air should not exceed 75%.

4. Coating Method

This paint can be applied using brush coating, airless spraying, and air-assisted spraying methods.

5. Dilute

Generally, paints require a matching thinner to adjust viscosity and clean tools. The amount of thinner directly affects the size of the paint pattern.

6. Coating Spacing

One-component paint is ready for subsequent coating after drying. For two-component paint, it is recommended to follow the coating interval as follows: