XT-10 Igniter Instructions

This igniter features a special high-performance power control chip design, widely used for igniting various gases, oils, and combustible solid particles (such as sawdust and wood), ensuring safe and reliable ignition.

Technical Specifications:

Power Supply: AC 220V, 50-60Hz

High-voltage output cable length: 3 meters

Input Voltage: 220V         Input Current: 1A

Output Voltage: 10KV Output Current: 50mA

Electrode Distance: 3-5mm

Housing: Explosion-proof box

Cautionary Notes:

1. Absolutely no connection of the ignition electrode to the ignition source without a connection.

2. The ignition electrode must be securely connected to the burner exterior.

3. The igniter's high-voltage output is the red wire, which must be connected to the ignition electrode to prevent accidental electric shock accidents.

4. Spark discharge occurs at the ignition electrode tip (far from the high-voltage wire end).

5. ZYG-20 Igniter Operation: Powers on with a 220V power supply to start ignition, with each ignition lasting approximately 5 to 15 seconds, followed by a 15-second pause before it can be used again. The ignition can be cycled repeatedly. Avoid continuous long-term use, as the igniter may be prone to damage.