The Dynamic Friction Coefficient Tester, also known as the "Wire Wool Abrasion Resistance Tester," is constructed with a stainless steel housing, aluminum alloy fixtures, and precision components. It boasts a precise structure and exquisite, attractive design, placing it at a high technical level among similar products.

The machine is suitable for wear resistance life tests of various surface coated products and printed characters.

Dynamic Friction Coefficient Tester (Abrasion Resistance Tester for Wire Wool) is used to measure the dynamic friction coefficient between two sliding contact surfaces.

Speed adjustable with intuitive speed display during testing, and the number of tests can be set; accurate test results, simple and easy operation.

Travel range: adjustable from 0-50mm

Speed: adjustable from 1 to 60 cycles per minute (round trip)

Friction hammer: comes with rubber and alcohol-resistant tools, and also includes a set of weights.

Counter: Up to 9999 counts

Total Power: 30W

Power: AC 220V, 50/60Hz

Dimensions: 550*400*330mm (Length*Width*Height)

　　Dynamic Friction Coefficient Tester Operating Conditions

At room temperature of 10℃-35℃, relative humidity should not exceed 80%.

In a vibration-free environment;

Surroundings free from corrosive media.

The fluctuation range of the power voltage should not exceed ±10% of the rated voltage.

The test machine's power supply should be grounded; the fluctuation of frequency should not exceed ±2% of the rated frequency.

Install correctly on a stable foundation.