The ZY5000S Radio Frequency (RF) Plasma Cleaning Machine, a plasma surface treatment system, primarily consists of three main components: the plasma nozzle, the plasma generator, and the control system.

　Product Principle

Wide-Range Low-Temperature Radio Frequency Plasma Cleaner - ZY5000S: The structure of the ZY5000S plasma cleaner is mainly divided into three major components, namely the high-voltage excitation power supply, plasma generator nozzle, and control system.

　　(H) High-voltage激励电源：+

The generation of plasma requires high-voltage excitation. Atmospheric low-temperature plasma is excited using a medium-frequency power supply, with a frequency range of 10-40 kHz.

High voltage ranges from 4-10KV. Parameters can be adjusted according to the actual sample conditions to achieve the desired modification effects.

　(B) Plasma Generator Spray Gun:

Atmospheric low-temperature plasma generator spray guns are available in two types: jet direct spray and rotating direct spray. The difference lies in the treated area.

　　(C) Control System:

The control system is designed to govern the operation of the entire atmospheric low-temperature plasma cleaning equipment, as well as to protect the overall system.

　Error Messages and Troubleshooting:

1 Water-cooled unit not powered on: Please check if the internal or external water-cooled unit is powered on.

2 Insufficient Argon: Please check if the argon is connected, if there is gas from the gas source, and if the pressure is greater than 0.3 Mpa.

3 Insufficient Oxygen: Please check if the oxygen is properly connected, if there is gas from the gas source, and if the pressure is greater than 0.3 Mpa.

4 Abnormal discharge: Please check if the RF power supply is turned on, if the reverse power is too high, or if the plasma gun head is discharging.

5 After troubleshooting, press the Stop button or the Fault Clear button

　　Note:No unauthorized disassembly or replacement of equipment components. For service, please contact us!

　Maintenance and care

　　Note: Before beginning any maintenance or repair, all necessary safety precautions should be taken, not limited to the contents mentioned in this user manual.

1. Turn off the equipment's power switch and disconnect the main power protector.

2. Shut off all gases.

3. Prepare the required tool kit.

4. Replacement of Water-Cooled Machine's Water (Must Use Pure Water) The water in the water-cooled machine must be changed after one month of use to prevent the formation of impurities that could cause blockages and lead to cooling issues with the nozzle, resulting in poor heat dissipation and potential damage to the nozzle.

5. Gun Tip Inspection: ① Check for any signs of peeling or burn marks on the negative plate (the bottom plate) of the gun tip; ② Inspect the ceramic tube (white) beneath the gun tip for cracks; ③ After applying power to the gun tip, observe if there is any backflow of water in the transparent tubes at both ends.

6. Conveyor Inspection: ①Observe the four corners of the conveyor. Check if the conveyor belt is rubbing against the profile rack. ②Inspect for any obvious signs of breakage on the conveyor belt.

(1) U.S. Circuit Technology:

Utilizing U.S. high-voltage excitation power circuit technology, it generates high-density plasma to ensure exceptional cleaning performance.

(2) Safety Protection:

Temperature safety protection, overload protection, abnormal pressure protection, short circuit and open circuit alarm protection, various incorrect operation protection functions.

　(3) Discharge technology available

Special processing and custom structures of discharge devices ensure the formation of a stable and uniform plasma.

(4) Matched with production line integration:

Tailored production line solutions based on on-site customer requirements significantly enhance production efficiency.

(5) Product Components:

All components of the product are made from top-tier domestic and international parts, ensuring superior equipment performance.

(6) Low Temperature Cleaning:

Meets temperature requirements for various occasions without affecting the washing product.

(7) Precision CNC Machining:

Imported precision CNC machine tools with processing technology, equipped with imported 3-axis measuring instruments for quality control.