Thermal Deaerator
I. Application of Thermal Deaerator:
☆Thermal deaerator is a device used to remove oxygen from boiler feed water, to protect the boiler from oxygen corrosion.

Compared to the spray tray-type thermal deaerator, the following advantages are present:
☆ Membrane deaerators are smaller in volume and lighter in weight, reducing costs when the same output power is achieved.
Wide output variation range, with stable deoxygenation efficiency.
Highly adaptable to water temperature, such as the water output oxygen content still meets the requirements under room temperature conditions.
Short startup to operational time.

The thermal deaerator heats the boiler feed water to the saturation temperature at the corresponding deaerator working pressure, removing oxygen and other gases dissolved in the feed water, and preventing and reducing corrosion in the boiler feed water pipes, economizers, and other auxiliary equipment.
The thermal deaerator has been proven to have the following advantages after operation and use in hundreds of power plants:
High deoxygenation efficiency.
2: Stable operation, no vibration. Even under a 25% load fluctuation, a 10% water replenishment fluctuation, and a drop in water temperature, the deaerator remains vibration-free and there is no boiling.
3: In addition to good adaptability, not being stringent in water quality and temperature requirements, etc., it can operate at about 50% over capacity. This is especially true for heating units and deaerators with slide pressure operation, which further highlight its superior performance.
4: Steam volume less than 0.1% of the inlet water volume; no additional exhaust cooler required. Consumes 1/3 less energy than other types of deaerators with the same output, optimizing the equipment and reducing heat consumption.

Section 3: Instructions for Ordering a Spiral Membrane Oxygen Remover
1. Required output, the volume of the water tank.
2. Oxygen Degetter Accessories Requirements
3. Oxygenator working pressure, temperature.