Laser welding machines cause the workpiece to rapidly melt and even vaporize upon absorbing laser energy. The molten metal forms tiny holes under steam pressure, allowing the laser beam to directly照射 the bottom of the holes, continuously extending them until the steam pressure inside the holes equals the surface tension and gravity of the liquid metal. This welding mode features deep penetration and a high aspect ratio. As the hole follows the laser beam along the welding direction, the molten metal in front of the hole flows around it to the back, solidifying to form the weld seam. Preparations Before Starting Up: 1. Check if the laser welding machine's power supply and water circulation are normal; 2. Verify that the gas connections inside the machine are properly set; 3. Ensure the machine surface is free of dust, stains, and oil.

Laser welding utilizes high-energy laser pulses to locally heat a small area of the material, with the energy from the laser radiation diffusing into the material's interior through thermal conduction, melting the material to form a specific molten pool for the purpose of welding. Fault 1: No power to start (power supply), (cooling), switch not powered. Solution: The water pressure switch did not activate. Remove the water supply pipe to exhaust air, then reinsert the water supply pipe. Fault 2: Light does not ignite. Solution: Check if the pre-ignition board has 220V; the condition of the 3A fuse, and if the xenon lamp is working. Fault 3: Light is on, but the laser soldering machine (automatic) state does not emit light. Solution: Check if the 3A fuse on the large printed circuit board is good; if the connectors are loose, and if the working voltage is >200V. Fault 4: Turn the voltage adjustment knob, the voltmeter shows no indication. Solution: The intelligent thyristor rectifier module is damaged, the voltage regulation board has a fault, check if the feedback button is closed, and if the wiring is loose. Fault 5: Suddenly no laser emission during operation. Solution: Check if the pre-ignition board's 3A fuse is good; check for power outages; and inspect if the laser chamber is leaking.

Teach you the correct operation and precautions for laser welding machines: 1. In the process of operating the laser welding machine, if an emergency occurs (such as water leakage, abnormal sounds from the laser, etc.), immediately press the emergency stop and quickly cut off the power to the laser welding machine. 2. It is necessary to turn on the external circulating water switch for laser welding before operation. 3. Since the laser system uses water cooling and the laser power supply uses air cooling, it is strictly prohibited to start the machine if there is a fault in the cooling system. 4. Do not arbitrarily disassemble any internal components of the machine, do not perform welding when the safety door is open, and strictly prohibit directly staring at the laser or reflecting laser with the eyes, or facing the laser welding head with the eyes while the laser is in operation, to avoid eye injury. 5. Do not...lFlammable, CombustiblelPlace explosive materials on the laser beam path or where the laser beam can reach to avoid fire and explosion.lCrush; 6. During operation, the machine is in a high-voltage, high-current circuit state. Absolutely no touching of the internal circuit components is permitted while the machine is running; 7. Untrained personnel are prohibited from operating this machine.




Laser Soldering Machine - Xile Intelligent Equipment (Online Inquiry) - Fuzhou laser soldering machines are provided by Xile Intelligent Equipment (Suzhou) Co., Ltd. Xile Intelligent Equipment (Suzhou) Co., Ltd. has poured a lot of enthusiasm and passion into this field. Xile Intelligent Equipment always puts customers at the center, creates value for customers, wins the market with quality and service, and sincerely hopes to cooperate with all sectors of society to create success and brilliance together. Related business inquiries are welcome, contact person: Wang Yan.