MS 5800U — Utilizes an integrated rotation detection system (IRIS) for inspecting ferrous and non-ferrous tube materials
Boiler
Water Heater
Air cooler
Heat Exchanger
The Ultrasonic IRIS option is used for detecting various materials, including ferrous, non-ferrous, and non-metallic materials. This technology detects and quantifies wall thinning due to corrosion, erosion, wear, pitting, cracks, and baffle cutouts. Olympus' digital IRIS inspection technology, a validated technique, is widely applied in far-field, magnetic flux leakage, and eddy current testing.
Key Features of MultiScan MS 5800U (IRIS)
IRIS Setup Wizard
For tubes of various diameters and materials, the wizard simplifies the calibration process of the detection equipment. The wizard also generates report codes for each inspection.
Real-time gain and gate control
During the C scan data collection process, the UT settings can be adjusted to quickly optimize the signal detection performance.
Real-time, continuous full-color C-scan
By utilizing C-scan imaging, the error of missing defects is reduced. The inclusion of color images and cross-sectional views of defects in the report enhances its quality and readability.
Complete Pipe Material Full Length Inspection Record
Used for analyzing data and evaluating results offline, together with clients.
Key Technical Specifications
Ultrasonic IRIS Inspection | |
Number of pulse generators/receivers | In pulse echo mode for 1 channel. |
System Bandwidth | 0.5 MHz to 25 MHz |
Sampling Rate | 8Bit 100MHz |
Probe Frequency | 1MHz～20MHz |
Pulse Repetition Frequency | At 20kHz. |
Dynamic Gain (Linear Amplifier) | 70 dB,Step size is 1 dB. |
AScan Length | 32~8092 points |
Pulse Voltage | 50V~300V, with a step of 1V. |
High-pass filter | 2MHz, 5MHz, 10MHz |
Data Collection Synchronization | Time, Contact, Location, or External |
Encoder | 2A perpendicular encoder and digital input. (Requiring MultiView 6.1 or higher version.) |
UT | Measurement Mode | Wall Thickness: IRIS (Immersion) |
Set Display | AScan | |
Contour measurement indicates | Color C-scans of the wall thickness, inner and outer walls, in the circumferential cross-section and the longitudinal section along the axis, as well as B-scans. | |
Cursor | Cross-sectional cursor and manual etching depth quantitative cursor | |
Measurement | Wall thickness loss (%), remaining wall thickness, and statistical data on the pipe geometry (minimum, value, average) |
