Basics and Key Details of Electronic Truck Scales

Electronic vehicle scales are increasingly being widely used. Always follow the manufacturer's instructions for proper installation.

In addition, there are also some key points that everyone needs to be aware of. Next, I will delve into a thorough analysis:

1. The vehicle's efficiency should be adjusted to 5Km/h or less; emergency stopping on the weighing platform is prohibited, and speed limit signs should be set.

2. Each time you place the vehicle on the scale, check if the indicator shows zero total weight; ensure the indicator reads level before printing or recording data.

Prohibition of using arc welding on electric truck weighing platforms or using the weighing platform as a grounding wire.

4. During the summer and autumn, ensure proper waterproofing measures are in place. The moisture-proof agent should be placed inside the wiring box of the electronic vehicle scale, without any deep foundation pit.

5. Metal bellows connection for electronic truck scales and cable lines.

6. In shallow and deep excavation pits, the drainage and sewage pipelines should remain unobstructed.

7. When temperatures are low during winter, the power switch of the instrument panel should be turned on for 20 minutes prior to precise measurements.

8. When installing an electronic vehicle scale, it is essential to avoid placing it in public safety corridors. It is strictly prohibited for non-measuring vehicles to quickly operate on the weighing service platform.

9. Electronic truck scales in the food industry or grain crop sector should implement fly prevention measures, and waterproofing work should be conducted at the junctions when cable lines break.

10. The load of each vehicle for precise measurement must not exceed the rated weight for weighing, but should not be less than the lower limit of 20d weighing.

11. Operators must not allow untrained employees to handle the dashboard.

12. Turn off the power switches for all weighing equipment at the end of the day. Prohibit vehicles from being left on the scale platform for extended periods or overnight.

Routine Regular Inspections and Maintenance for Electronic Truck Scales

Throughout the entire application process of the electronic truck scale, it is crucial to strengthen daily regular inspections and maintenance, focusing on several key aspects: (1) whether the scale body is stuck; (2) whether the positioning is blocked; (3) whether the sensors are misaligned; (4) whether the connections in the junction box are loose; (5) whether the connections to the instrument panel, computer, display screen, and computer keyboard are secure; (6) operational errors that may result in the loss of tare or net weight. Overall, it includes the following aspects:

Inspect and adjust the relative height of dining tables. Due to various reasons, the truck scale has been in use for a long time, and the surface of the scale has experienced some deformation. The longer it is used, the more severe the deformation becomes.

Common Questions About Our Instrument Equipment Application:

(1) This instrument equipment must only use an independent lamp switch power supply; it is strictly prohibited to derive it from a three-phase four-wire system, and no equipment that may affect it should be present on the same instrument.

(2) The power supply for the instrument equipment should be set with an independent wire connection.

(3) The scale platform does not affect the machine equipment.

The key to whether a load-bearing service platform meets standards is the diagonal dimensions of the four sensors at the points of load-bearing, as well as the vertical and horizontal errors along the axis and front-to-back as well as left-to-right errors.

Check for loose connections, disconnections, or short circuit issues; if detected, they should be repaired immediately.

Do not stuff stones, coal, or other debris into the gaps around the weighing platform.

Regularly inspect if the clearance limit is valid; the foot bolts should not strike the weighing body. Generally, the gap is 2-3 mm.

Perform maintenance and lubrication on the radio frequency connector every six months, applying unsalted butter to the top of the support head.

Regularly clean the scale platform surface, maintain cleanliness, and repaint the surface as scheduled.