X-ray Coal Intelligent Sorting and Inspection System

The device primarily operates through a continuous conveyor belt movement, transferring the inspected coal in and out via the conveyor belt to the sorting station, which is the X-ray digital sorting detector. As the inspected coal enters the line array imaging area in various specifications, the computer has already prepared the identification information through calibration and self-learning modules. The computer identification software detects the density information of the inspected coal blocks and gangue, transmitting their coordinate information to the lower computer or sorter. After the tested coal leaves the line array and moves outside the lead room, the sorter sorts it. The entire detection cycle is completed.

Features of the Equipment

Wide resolution range

Low noise, high dynamic range, high sensitivity, high MTF

16-bit dynamic range

The signal scan speed remains consistent according to the configuration.

Device Driver

Standard Application Interface:

Application Areas: Coal and Coal Slag Sorting

Detector: Special design, suitable for coal sorting

Effective Detection Length: 1140mm

Total Channels: 448

Ray Source: 200KV, 2.5mA

Technical Specifications

Inspection Belt Width: 1200mm

Coal dry selection specifications: 80mm - 200mm

Ray data transmission method: Gigabit Ethernet port.

Positioning Accuracy: 3mm

Belt conveyance speed: 1-2 meters/second.