XiangkeDRPL-III-300Fully AutomaticThermal Conductivity Tester (Insulation Material Thermal Conductivity Meter Using Protective Plate Heat Flow Meter Method)

One, Overview

 This instrument employs internationally popular heat flux meter methods to measure thermal conductivity and thermal resistance, with a computer for full-automatic testing and report generation. Suitable for testing the thermal conductivity of insulating materials, refractory materials, and other low-conductivity materials, it can also be used for powder material testing with the addition of a sample frame. Widely used in colleges and universities, research institutions, quality inspection, and factories.

This instrument conforms to the following reference standards:JIS-1412-2Method for measuring the thermal resistance and thermal conductivity of thermal interface materials、GB/T10295-2008、ISO 8301：1991 Thermal Resistance and Related Properties of Insulating Materials Determined by Heat Flow Meter Method) andASTM C518-04Method for measuring steady-state heat flux and heat transfer characteristics using a heat flux meter.

Two、System Composition:

a) Hot surface heater, high precision programmable temperature control, hot surface temperature resolution0.1℃，

b) Cold noodles are controlled by a constant temperature water tank, with fluctuations less than0.05Degrees, cold surface temperature resolution0.01℃。

c) Adding protective monitoring devices can effectively eliminate environmental impact on testing, ensuring test accuracy and repeatability.

d) Equipped with automatic pressure and thickness measurement functions, capable of detecting thermal conductivity and thermal resistance under different pressure conditions.

I.Key Parameters:

1、Thermal conductivity range and accuracy: 0.0010～3.0000W/mk，DisplayFour decimal places

2、Measurement Accuracy:±3%.Repetitive: ±1 %.

3、Sample Size:300×300（mm）,Thickness not exceeding5～50mm。

Special sizes available for customization: such as200×200（mm）、250×250（mm）、600×400（mm）、600×600（mm）Various specifications;

4、Testable for solid materials and powdered materials.

5、Hot Water Temperature and Control: Room Temperature~100°C (Standard Configuration),Temperature Resolution0.01℃

Determine higher temperatures according to customer requirements, such as room temperature up to~300℃，Temperature Resolution0.1℃。

6、Cold Noodles Temperature and Control:5~80°C (Standard Configuration),Supplied0～Constant temperature water bath at 99.99℃Control,Temperature Resolution0.01℃。

Alternatively, low-temperature detection can be selected according to customer preference.-20～80℃、-30～80℃Same specifications, additional costs apply.

7、The sample is clamped with precision using computerized pressure.,Pressure Range0-1000N,DistinguishRate0.1N。

8、Automatic Sample Thickness Measurement, 0-50mm,Resolution0.01mm 。

10The testing section features a transparent organic glass wind shield, with a side door for viewing the testing conditions inside the instrument.

11、Install protective control devices to effectively eliminate environmental impact on testing, ensuring precision and repeatability.

IV. Equipment套装性

1、DRPL-III-300Thermal Conductivity Tester Main Unit1Taiwan

2Test Software (including communication interfaces)1Set

3Constant Temperature Water Bath and its Controller1Set

4、Computer1 unit (optional for the buyer to provide)。