DRL-VIIIThermal Conductivity Meter
One,Overview
This instrument primarily tests the thermal resistance of thin thermal conductors, thermal conductive silicone sheets, thermal conductive resins, beryllium oxide ceramics, aluminum oxide ceramics, and other small materials, as well as the contact thermal resistance at solid interfaces and the thermal conductivity of the materials. The materials to be tested are usually in solid, sheet form, and can also detect powdered and paste-like materials with the addition of a frame.
Instrument Reference Standard:MIL-I-49456AInsulating Sheet Materials, Thermal Conductive Resin, Heat-Conducting Glass Fiber ReinforcementGB 5598-85Method for Measuring Thermal Conductivity of Beryllia CeramicASTM-D5470-12Standard for Testing Thermal Conductivity of Thin Solid Electrical Insulating MaterialsASTM E1225-2020By isolating-Compare-Method for measuring the thermal conductivity of solids using vertical hot flow technologyGB/T38712-2020Thermal Conductivity Test Method for Ultra-Thin Glass (Heat Flux Method)GB /T29313-2012Methods for testing thermal conductivity of electrical insulating materials.
The instrument features automatic pressure, automatic thickness measurement, and full computerized automatic measurement control functions.DRL-8Type instrument isDRL-3、DRL-5Developed from a model instrument, it can be widely used for material thermal analysis testing in universities and colleges, research institutions, quality inspection departments, and production factories.
Two,Key Parameters
1Thermal resistance measurement range:0.01～200 （cm2*k/w); Tolerance ≤ ±3％±0.01。
2Thermal Conductivity Measurement
2.1General Mode Range:0.1～45 （W/m*k); Tolerance ≤ ±3％±0.005。
2.2High Conduction Mode Range:5～500 （W/m*k); Tolerance ≤ ±5％。
3Temperature Measurement
3.1Temperature Resolution0.01℃; Tolerance ≤ ±0.1℃
3.2、Hot extreme temperature control range: (Room Temperature+10℃）～200.00℃
3.3、Hot noodle temperature control range:Room Temperature+10℃）～150.00℃
3.4、Cold extreme temperature control range: 5～60.00°C (constant temperature bath)
4Pressure Measurement
4.1Pressure Measurement Range:0～1000.0NError ≤ ±0.1％FS。
4.2Pressure Control Range:20～500.0N
5Thickness Measurement
5.1Used3Displacement gauge measurement.
5.2Measurement Range:0～10.000mm±0.5%0.005mm。
6Load/Unloading Control: Stepper Motor.
7Test Head Diameter: Φ30mm。
8Computer-controlled experimental method
8.1Thermal Conductivity Test
8.1.1Common Measurement Modes
8.1.2High Conductivity Measurement Mode
8.1.3Block measurement mode
8.1.4Composite Layer Measurement Mode
8.2Thermal Resistance Test
8.2.1Set pressure measurement mode
8.2.2Set temperature measurement mode
8.2.3Set thickness measurement mode
8.2.4Set Time Measurement Mode
8.2.5Custom垫块InterfaceMethod
8.3Compressibility Rate Test
9Motherboard Power Supply: Voltage220VFrequency50HzPower less than1KW。
10Mainframe dimensions:700×720×1700（mm）
Instrument Configuration: DRL-VIIIThermal Conductivity Tester Unit 1; Test Software (including communication interface) 1 set; Constant Temperature Water Bath and its Controller 1 set; Computer 1; Colloidal Material Sample Box 2; Quartz Standard Sample 1.
