Pneumatic Liposome ExtruderPrimarily used for particle size homogenization of pharmaceutical products, removal of particles and sediments, reduction of liposome and emulsion particle sizes for easier sterile filtration, and molecular biodynamics research.

Pneumatic lipid extruderExtrusion Principle:

After hydration and formation of liposomes, the sample is typically subjected to initial homogenization through high-pressure homogenization or ultrasonic treatment. This process improves the particle size and distribution of the sample, but often does not meet the desired ideal requirements. At this point, the homogenized sample is fed into the extruder through the inlet shown in the figure below, and is extruded through a filter membrane using high-pressure nitrogen. This further enhances the particle size and distribution of the extruded sample.

Liposome ExtruderTechnical Features:

All components, including "O" rings and washers, are FDA-certified.

2. Utilize PC filter membranes for easy operation and reusable convenience.

All contact material pipes are made of 316L material.

4. Strictly control product particle size, available for single or cyclic operation.

5. Easy to load and unload, convenient for cleaning and sterilization.

6. All data can be zoomed in directly.

7. Pre-set pressure relief valve.

8. Suitable for high-concentration sample processing.

9. Suitable for use in cleanrooms, compliant with GMP standards.

All components, including "O" rings and washers, are FDA-approved.

2. Utilize PC filter membranes for easy operation and reusability.

All contact material pipes are made of 316L material.

4. Strictly control product particle size, available for single or cyclic operation.

5. Easy to load and unload, convenient for cleaning and sterilization.

All data can be zoomed in directly.

7. Pre-set Pressure Relief Valve.

8. Suitable for high-concentration sample processing.

9. Suitable for use in cleanrooms; meets GMP standards.