• Product Overview

• Performance Features

• Technical Specifications

Ignition LeverUser Manual

High-energy igniterSpecialty ignition rod for automatic ignition of industrial burners. The product features high energy, high-temperature-resistant firing tip, resistance to carbon accumulation and agglomeration, self-cleaning capabilities, and high reliability in ignition. The ignition rod is easy to install with no need for adjusting the firing electrode discharge distance.

1. Ignition Rod Technical Specifications

Ignition Rod Applicable Fuel - Gas

2. Ignition Rod Discharge Voltage: 2500V

Ignition Frequency: 8-16 Hz

4. Ignition Endure High Temperature - Long-Term 1300 Degrees

5. Front end material of the ignition tip is 2520 high-temperature material, with the rear being 304 stainless steel.

6. Ignition rod connection and installation thread M18*1, dimensions and shape made according to customer requirements

2. Ignition Rod Installation and Wiring

Hole the burner and machine an M18*1 mounting thread at the opening; simply screw the ignition rod in place. This ignition rod features a new design structure, eliminating the need for adjusting the sparking distance.

The ignition rod's firing end is mounted 20-30mm in front of the burner nozzle, with the gas burner mouth having a smaller distance.

Ignition Rod ConnectorIgnition WireConnected to a high-energy igniter.

III. Usage Requirements

This igniter is a high-energy ignition, with the ignition rod's firing end resistant to carbon buildup. It can still ignite even under carbon buildup conditions, so users do not need to clean the firing end during use and can operate with confidence.

2. Each ignition rod点火 takes 10-15 seconds, followed by a one-minute rest after ignition. Ignite again next time. Avoid prolonged use to extend the life of the ignition rod, which has an average lifespan of 100,000 ignitions.

3. The front end of this ignition rod features a special structure; users cannot saw off a section of the rod and use it.