Mine Wire Rope Core Stripping Machine, Belt-Pulled Stripping Machine, Laminated Tape Stripping Machine
Preparation for vulcanized joints on steel wire rope conveyor belts, specifically designed for separating steel wire rope cores from rubber. This equipment can be used in various situations and locations where bonding is required, with its convenient operation significantly reducing the working time needed for bonding steel wire rope core conveyor belts, effectively lowering the labor intensity of the operators. Suitable for steel wire rope spacing≤25mm,Diameter ofφ4.9～φ13.2mmSteel wire rope core conveyor belt,Covered rubber layer thickness, bearing surface25mm,Non-carrying surface12mm,Total Tape Thickness≤43mm。
Section IITechnical Specifications:
1.Motor Power:1500W
2.Working Voltage:380V
3.Line Speed:0.3m/s
4.Wire rope diameter:φ4.9～φ13.2mm
5.Conveying thickness:≤43mm
III. Features:
1.No need to flip the belt; the removal of the rubber covering on both ends of the steel wire rope can be done in one go.
2.The thickness of residual adhesive on the steel wire can be arbitrarily controlled to ensure vulcanization strength.
3.Compared to the traditional manual deheading method, it is more user-friendly, saves a significant amount of time, and greatly reduces labor intensity.
IV. Structure:
This equipment is divided into the electric traction section and the working section. The electric traction section operates the working section through a wire rope.
V.Usage Instructions:
1.Confirm headstock dimensions and mark as shown in the diagram.
2.Peel out along the marked line with a knife.200mmBroad bare steel wire rope;Two-belt joint section
Remove the rubber until the steel wire rope is exposed.
3.Select appropriate upper and lower blades based on the wire rope diameter.
Wire rope diametermm | 3.0-5.5 | 6-7.5 | 8-8.5 | 9-9.5 | 10-10.5 | 10.5-11.5 | 12-13.2 |
Blade tip radiusmm | 3 | 4 | 4.5 | 5 | 5.5 | 6 | 6.5 |
4.Adjust剥壳机：① Verify if the upper and lower blades are parallel. ② The pressure roller and lower blade are on the same vertical line. ③ The horizontal distance between the upper and lower blades is equal to the wire rope spacing (loosen the bolt on the upper blade clamp and move the upper blade position).After the actuating mechanism is tightened, adjust the distance between the pressure roller and the lower blade by turning the bolt. Ensure the wire rope stripping is even both up and down.
