Wire Rope Core Stripper / Belt Peeling Head Clamp
Preparation for the vulcanized joints of steel wire rope conveyor belts, specifically designed for separating steel wire rope cores from rubber. This equipment can be used in various situations and locations where bonding is required, significantly reducing the working time needed for bonding steel wire rope core conveyor belts due to its convenient operation, effectively lowering the labor intensity of the operators. Suitable for steel wire rope spacing≤25mm,Diameter ofφ4.9～φ13.2mmWire rope core conveyor belt,Thickness of the rubber layer covering the bearing surface25mm,Non-bearing surface12mm,Total Adhesive Tape Thickness≤43mm。
Two,Technical Specifications:
1.Motor Power:1500W
2.Operating Voltage:380V
3.Line Speed:0.3m/s
4.Wire rope diameter:φ4.9～φ13.2mm
5.Conveying thickness:≤43mm
Section 3: Features:
1.No need to flip the belt, as the removal of the rubber cover on the wire rope can be done in one go.
2.The thickness of residual adhesive on the steel wire can be arbitrarily controlled to ensure vulcanization strength.
3.Compared to traditional manual deheading methods, it's more user-friendly, saves a significant amount of time, and greatly reduces labor intensity.
IV. Structure:
This equipment is divided into the electric traction section and the working section. The electric traction section operates the working section through a steel cable.
FiveInstructions for Use:
1.Confirm the headstock size and mark the lines as shown in the diagram.
2.Peel out at the underlined position with a knife.200mmExtruded steel wire rope;Two-bolt joint belt section
Please remove the rubber until the steel wire rope is exposed.
3.Select appropriate cutting blades based on the wire rope diameter.
Wire rope diametermm | 3.0-5.5 | 6-7.5 | 8-8.5 | 9-9.5 | 10-10.5 | 10.5-11.5 | 12-13.2 |
Blade tip radiusmm | 3 | 4 | 4.5 | 5 | 5.5 | 6 | 6.5 |
4.Adjust剥头Machine① Verify if the upper and lower blades are parallel. ② The pressure roller and lower blade are on the same vertical line. ③ The horizontal distance between the upper and lower blades is equal to the wire rope spacing (loosen the bolt on the upper blade clamp to move the upper blade position). ④After the actuating mechanism is tightened, adjust the distance between the pressure roller and the lower blade by turning the bolt. Ensure the wire rope head is剥开 evenly up and down.
5.Press the blade over a steel wire rope, tighten the operating mechanism, activate the electric traction machine's blade movement, and it can evenly strip the rubber from the wire rope.
6.Press the upper blade against two steel wire ropes, the lower blade hold one steel wire rope, tighten the operating mechanism, start the electric traction machine's blade movement, which can evenly peel off the rubber from the steel wire ropes, peeling off the rubber layer by layer inward.
