Belt Skinning Machine, Vulcanizing Machine, Steel Wire Rope Head剥机, Electric Tape Peeling Machine

Enable Please provide the Chinese content to be translated. Please provide the Chinese content that needs to be translated into American English. Ming Book

I. Feature Overview:

剥皮器 for conveyor belt joints, especially suitable for nylon and canvas belts. Nylon belts can be stripped in widths up to 350mm at a time. Enhances jointing efficiency and reduces labor intensity.

The XLP-100 electric stripping machine's advantages include its use of 220V voltage, which reduces electrical preparation at the junction site. Additionally, the machine weighs only 21 kg and is equipped with a carry handle for easy portability.

Composition:

 The XLP-100 Electric Stripping Machine consists of a handheld controller (1), an electric motor (2), a reducer (3), a wire rope drum (4), a rear fixing sleeve (5), a handle (6), and a mechanical arm (7). The electric motor outputs power, which is reduced by a meticulously designed reducer, driving the wire rope drum. This, in turn, moves the mechanical arm at one end in and out to complete the stripping operation.

The total length of the wire rope is 6 meters. When preparing for the stripping operation, pay attention to the distance between the stripping position and the fixed position of the stripping machine; it must not exceed 6 meters.

Before peeling with the stripping machine, use a fixing sleeve to secure the machine to a sturdy location. The stripping machine's maximum pulling force is up to 500 kg, so it needs to be sufficiently strong. If this is not possible on-site, reduce the width of each strip to decrease the pulling force.

Section 3: Peeling Operations

 One person operates the handheld controller button, one person

 Tighten the end wire rope of the robot arm until it reaches the剥皮 target.

 The steel wire rope is loosely coiled around the drum.

Grip the end of the belt layer with the robotic arm and lift the arm.

Handle, separating the front board from the movable board. Place the belt layer

Insert the end between the two boards, press down the handle to clamp the belt. Hold the button on the handheld controller to start peeling layers. The gripping force of the mechanical arm on the belt is proportional to the tension of the steel wire rope. Therefore, once the wire rope is tightened, the operator can release the handle, allowing the mechanical arm to move freely.

 This stripping machine can strip off the layer from the nylon belt in one go.350mm (with both sides fractured along the peeling line). The width of the robot arm is 250mm.