Electric Belt Sander Model 1520*200, Vertical Belt Sander, Woodworking Belt Sander

Floor-mounted grinding machines are mainly supplied to general industrial and mining enterprises for operations such as grinding of small parts, deburring, and cleaning castings.,Can also be used for sharpening common cutting tools.

 2.The pedestal grinding wheel machine is not resistant to chemical corrosion and should not be used outdoors.

Usage and Maintenance

1. The grinding wheel machine before use                  Please provide the Chinese content you would like translated into American English.The Megger above 500 volts measures its insulation resistance, which is not less than 0.5 megohms.

2. Prior to use, the grinding wheel machine should be thoroughly inspected for any damage or cracks in the parts due to transportation, and check for loose fasteners. If any are found, they should be tightened.  Ensure even tension. Pay special attention to the grinding wheel for any cracks. Gently tap with a wooden mallet; a clear, crisp sound indicates it's safe to use.

3. Prior to use, the grinding wheel machine should be manually rotated to check for smooth operation and listen for any rubbing noises.

4. The direction of rotation for grinding wheels and fans should match the direction indicator.

5. Do not allow the workpiece to collide with the grinding wheel during operation.                  Gradually apply pressure to prevent the abrasive wheel from being impacted, thus avoiding an explosion and any accidental incidents.

6. The abrasive wheel machine guard is strictly prohibited from being removed, except for the replacement of the abrasive wheel and maintenance disassembly.                                                                      。

7. Two grinding wheels have been worn down to a difference in diameter.            No larger than20%。

8. Replace with a new grinding wheel. Ensure the wheel is balanced during installation, and the soft pad between the wheel and the mounting plate should be properly seated. Do not tighten the nut too much to prevent the wheel from cracking.            After                  Secure the protective cover.

9. The lubricating grease in the bearings should generally be replaced every six months.

10. The M3030, M3035, and M3040 vertical grinding wheels are equipped with a worktable. When using the worktable, ensure that its supporting surface is at the same height as the motor's shaft centerline. After adjusting the height of the worktable,                  Secure properly.

11. The grinding wheel machine should not be exposed to dampness or freezing during storage to prevent cracking of the insulation surface, which may affect the normal operation of the machine.