The heating element of the constant power parallel electric heater is a tightly and uniformly wound heating wire around the busbar insulation. The heating wire is connected to the busbar sequentially at fixed intervals (heating section length), forming a stable parallel circuit along the length of the busbar when voltage is applied.

In constant power parallel heating cables, continuous heating resistive wires form a series of interconnected parallel heating sections – heating sections, each of which is independently separable for trimming according to requirements (except for fire-resistant constant power parallel heating cables).

Constant power parallel electric heating cables cannot be used alone; they must be paired with a explosion-proof temperature controller and explosion-proof accessories that are compatible with the environment.

In areas of Factory Zone 1 and 2 with explosive gas T4 groups, the explosion-proof temperature controller's set temperature should not exceed 110°C. The temperature sensor is mounted on the outer sheath at a high temperature point to ensure the surface temperature of the electric tracing heating does not exceed 130°C.

Constant Power Parallel Heating Cable Structure Diagram

1. Constant Power Parallel Electric Heating Cable Model Description

2. Main Technical Parameters of Constant Power Parallel Electric Heat Tracing

3. Constant Power Parallel Electric Heating Cable Performance Comparison Table

4. Applicable Locations:

Constant power parallel electric heating tape is suitable for pipe and equipment frost and condensation prevention in the following situations:

·Safe Zone

· Hazard Zones 1 & 2; Zones 21 & 22;

·Moist and salt spray environments; corrosive conditions.