Zhejiang Baifu Servo Drive AX5140 Alarm F146 Fault Repair
F146, Build drive system: FailedThe system initialization has failed due to a general error.
F146, System Initialization Failed: Due to general error, the build drive system could not initialize.
Diagnostic Code (Hex.)
Diagnostic Code (Hexadecimal)
Diagnostic Code (Dez.)
Diagnostic Code (Dez.)
Software exception
Software anomaly
standard Reaction
Standard Response
Reset
Reset
Shorted coils brake
Short-circuit disk brake
Execute Reset-Command (S-0-0099).
Execute reset command (S-0-0099).
Possible Causes
Possible Causes
solutions
Resolve
There is an internal hardware or software error.
There is an internal hardware or software error.
Disconnect the servo drive from the mains (includingthe 24 v power supply) and start a new attempt. lfthis error occurs repeatedly, please call the Beckhoffbranch office that is responsible for you.
Disconnect the servo driver from the power supply (including the 24V supply) and start a new attempt. If this error recurs, please call the Beckerhoff branch office responsible for your work.
Common repair issues with Zhejiang Baifu servo drives: machine explosion, module explosion, unable to drive load, spindle not ready, driver not enabled, encoder alarm fault, spindle drive module alarm, low output voltage, red light on, no display, phase missing, output control point failure, abnormal enable, fault reported, unable to start, overcurrent, overvoltage, undervoltage, overheating, overloading, output imbalance, no display, power supply failure, module damage, grounding fault, unable to adjust speed, current limiting operation, Z-axis alarm, X-axis unable to enable, Y-axis short-term drive fault repair, drive motor inverter error, shaft servo fault, servo motor not rotating, etc.