EHS-4PType Double Channel SteelOverheating and burningNon-Destructive Testing Automatic Sorting Machine

Instrument Introduction:

   1.Cast iron, ductile iron, wear-resistant cast iron, and malleable cast iron (commonly known as malleable iron) hardness sorting, various cast iron products 

     Hardness testing after normalizing, annealing, quenching, or tempering can all be automatically sorted using this system.
   2.Hardness testing and sorting for normalizing and annealing parts of any steel grade, such as various thread rolling parts, gears, etc.
   3.Water heating pipe fittings hardness sorting.

FeatureFeatures:
    1For assessing the hardness of workpieces that meet and do not meet the requirements after heat treatmentNon-destructive automatic sorting. Workpieces with qualified hardness and no defects. 

      Qualified hardness workpieces will be automatically separated by the sorting gate.
   2Count separately the workpieces with qualified hardness and those with unqualified hardness (upper and lower limits).
   3The main control instrument of the separator features a dynamic bar chart display of the workpiece hardness status. Under normal process conditions, the bar chart shows:  

      The amplitude reflects the hardness of the measured workpiece, with strong intuitiveness.
   4With the selection of the main control instrument, there is a function key for setting the upper and lower limits of the hardness range, convenient for the operator to use, when... 

      If the hardness of the tested workpiece exceeds the upper limit or falls below the lower limit, the instrument will trigger corresponding light and sound alarms, and will combine 

      Signals for grade and ungrade are sent to the sorting machine's actuator for sorting.
   5On the panel of the sorting machine's electrical control box, there is a hardness status indicator light for the workpiece being tested, which turns green to indicate that the workpiece is in a hard state. 

       Piece hardness meets specifications. The red light indicates that the piece hardness does not meet specifications (exceeds the upper limit or falls below the lower limit). When the piece hardness 

       An audio-visual alarm is also activated upon failure.
   6Sorter main control instrument capable of storage9Magnetic flux limits for various specifications and sizes of workpieces.1Invoice Number 

       2Bill of Lading3Lot Number4Numbered documents…9Numbered pieces represent different specification and size of the inspected workpieces, convenient for users. 

       Direct call.
   7Data setup, data query, historical records, time display, hardness state display, and compatibility with human-machine interface 

       Statistical function for good and defective pieces.
   8The separator utilizes dual channels for detection, enhancing the speed of the process.

Instrument specifications:
     1Testing Speed
         Single-channel:<5s/Piece
         Dual Channel:<2s/Piece
    2Detection Accuracy:
        Beloit Hardness:<±13HB
    3Equipment Weight:<500Kg
    4Compressed air pressure range:0.4Mpa-0.8Mpa
    5Power Supply:220±10V
    6The workpiece to be tested should meet the following requirements:
        Same material, same specification and size, same surface condition, same heat treatment process, surface free of serious 

        Defects.
    7Mechanical transmission section: Long×Wide×High=2000×1000×1600mm(Customizable)

Work Environment:

    Operating Temperature:-15~55℃

    Storage Temperature:-20~60℃

    Relative Humidity: Not exceeding85%

Operating Voltage:AC220±10V

Sorting and inspection corner:

Sorting and inspection corner: