Waterborne polyurethane paintTMJ2K-M4

Application Scope:This productWidespreadShouldForA variety of machinery and equipment.Protective coatings for stainless steel, aluminum alloys, galvanized steel, iron, and other metal surfacesCoatingOrnament，And for pipeline systems for oil, gas, and water transmission, gas cylinders, etc., provide protective coatings for both structural repairs and new construction anti-corrosion systems.

Composition and Performance:ThePaintIt is a two-component mixed paint, divided into paint sections.ACuring agentBAll are ground from modified resins, cross-linking agents, pigments, etc., and can be either air-dried or baked dry.。

1. The coating exhibits excellent adhesion, boasting superior bonding strength to steel, galvanized steel, and light metals.

2. Excellent resistance to alternating dry and wet conditions, oil resistance, superior three-proof properties, and resistance to humidity and heat.

3. The coating dries quickly, is resistant to water, acids, alkalis, and salts, has good physical and mechanical properties, and can be baked at low temperatures.

4. High fullness, aging resistance, and film-forming properties.

Technical Specifications:

1、Solids content∶≥50±1%；

2、Gloss∶High-gloss, Matte；

3、Hardness∶2HAbove；

4Touch Dry:15-20Minutes, fully cured:24~48Hour(s)

5. Flexibility:≤3mmAdhesion: ≤0Grade; Repairable; ≤1Grade

Construction Methods and Precautions

1、Construction Mix Ratio (Weight Ratio): PaintA: Binder to Pure Water = 100:25; 25~75

2、AAfter the component barrel is opened, it must be thoroughly mixed, then under the mixing, it should be added according to the required proportions.BGroupPiecePourAIn the composition, fullyMix thoroughly, allow to stand, age30 minutesAfter, add适量Pure WaterAdjust to construction viscosity.

3、Construction Method∶Spray painting, brush painting，Roll Coating;

4、Substrate temperature must be higher than the dew point.3Above 5℃, when the substrate temperature is below 5℃, the coating will not cure, thus it is not suitable for application.。

5、Dry Conditions∶Room temperature self-drying or drying60~100°C）X（30Minute(s)

6Note: Ensure that the anti-rust primer and intermediate coat are fully cured, with a clean and dry surface, free of contamination, before applying the topcoat. Overcoating on surfaces that have not fully cured may sometimes cause color bleeding, pinholes, and other unknown defects.

Packaging and Storage：

1、Standard Packaging∶ 4kg/Bucket 20kg/Bucket  Curing Agent:1kg/Bucket2kg/Drum

2、Store5-30Store in a dry, well-ventilated area; shelf life will significantly shorten under high temperatures or exposure.

Colors: Transparent, Red, Orange, Yellow, Green, Blue, Black, White, Gold, Silver, etc., Custom color available

 Guangzhou Tianmai New Material Technology Co., Ltd.