Our company produces filtration equipment, wastewater purification and emission reduction, equipment rental, free sample trial upon request.
24-Hour Technical Support Hotline: 18017746299
SYJP Series Oil Filter Machine
This equipment is specifically designed by our company for the filtration and dehydration of medium to low viscosity hydraulic oils used in turbines, injection molding machines, die casting machines, stamping, etc. It integrates both oil filtration and efficient dehydration, effectively separating impurities, water, and gases from the oil. After the recycling process, the water content in the oil is less than 100ppm, and the particle impurities meet NAS 4-8 standards.
This equipment's:
High-performance polymer materials are chosen to replace traditional filters, filter papers, and cores, effectively resolving various clogging issues caused by oil sludge and bacterial film contamination.
SYJP Type Oil Filter Technical Specifications Table:
Machine Type | SYJ P-1 | SYJ P -2 | SYJP-3 | SYJ P- 5 | SYJP-10 | SYJP-16 | SYJP-20 |
Treatment Volume (L/H) | 60 | 120 | 180 | 300 | 600 | 900 | 1200 |
Voltage/Capacity (V/KW) | 380/0.25 | 380/0.35 | 380/0.5 | 380/0.55 | 380/0.75 | 380/1.1 | 380/1.5 |
Applicable Viscosity (cSt) | 320 | ||||||
Operating Temperature (°C) | 90 | ||||||
Design working conditions | Offline or Online Filtering | ||||||
Medium | Turbine oil, hydraulic oil, synthetic oil, and other petroleum-based oils | ||||||
Tube Inner/Outer Diameter | Dg50/Pg16 | ||||||
Export Oil Water Content (PPm) | <100 (Total Moisture) <50 (Free Moisture) | ||||||
Export oil particle size | NAS4~ 8 | ||||||
Ripeness degree (min) | <15 | ||||||
Working Pressure (Mpa) | <0.5 | ||||||
Import Pressure (Mpa) | >-0。045 | ||||||
Aircraft exterior design | Based on customer requirements | ||||||
Features and Effects:
1. Modular design, saving costs for your product's upgrade and replacement.
2. Achieves clean state with just one filtration: particle size up to NAS 4~NAS 8.
3. Features a one-time filtration de-emulsification function, which is not available in similar products. The water separation material achieves an effect with the oil containing less than 100PPm water and free water content below 50PPm.
4. High dirt-holding capacity, long service life, with minimal need for frequent maintenance or replacement of parts.
5. It can remove sub-micron particles (such as oil sludge), which is something that a full flow filter cannot do.
6. Purify oil products using pure physical methods, separating moisture without heating, low electrical consumption, and cost-effective maintenance.
7. Oil-water interface sensor, flexible separation of water and waste discharge system, and monitoring system; discharge water meets national emission standards (optional).
8. The main oil pump utilizes a low-noise internal gear pump of international standard, equipped with an oil-pumping and filtration conversion unit, convenient for dual-purpose oil pumping or filtration.
9. Full automatic control, self-locking in case of failure, dual protection of mechanical and electrical controls, minimizing oil leakage incidents. Easy installation, simple operation, and fully automatic operation; no need for manual supervision.
