Washing Tank Operation Procedure

One, water tank cleaning and disinfection personnel (including full-time pharmaceutical preparation staff) must undergo a physical examination by the health department annually.

Receive a physical examination certificate, and after passing the training, you can start working. Immediately transfer out any patient with "five diseases" from the post.

Pleasure

Employees should wear clean work clothes, boots, rubber gloves, and lighting equipment when cleaning and disinfecting.

Please bring the equipment and specialized cleaning tools (which must be cleaned and disinfected) into the drum.

Step 3: Procedures for Cleaning and Disinfecting Water Tanks (Pools)

Notify residents in advance.

2. Close inlets and outlets, valves

3. Open the drain valve or start the submersible pump to lower the water level to about 30cm, then close the drain valve or stop the pump, and block the outlet to prevent debris from entering.

4. The tank cleaner must bring the special tools and water nozzle into the tank (tank) for cleaning and washing. The top and rear of the tank (tank) should be cleaned from inside to outside, and damaged parts should be repaired promptly.

5. Wash and inspect; open the drain valve or start the submersible pump, drain the wastewater and rinse with clean water; close the drain valve or submersible pump

6. Apply the prepared disinfectant uniformly from top to bottom, spraying the surface of the box (tub) wall from the inside to the outside. Suitable for openings, box (tub) openings, and hole covers, etc.

7.30 minutes later, open the inlet valve. When the water tank is full, open the drain valve or start the submersible pump to drain water, and restore water supply.

8 (After water supply is restored, it should be delivered to the health station for water quality testing.)