1． Design complies with the following specifications::
Cabinet meetsSEFA Relevant standards, and bySEFAProposed inspections for load-bearing, impact resistance, and chemical corrosion, among others.
Note:Scientific Equipment and Furniture Association (SEFA) American Association of Scientific Laboratory Equipment and Furniture
All basic cabinets are made of full steel, pre-formed, and pre-opened structures. The intersection angle planes are smooth in both vertical and horizontal directions, without any overlapping or cracking. The door and drawer panels are on the same plane, with sound-absorbing materials inside the panels.
The basic cabinet is an independent, detachable structure. The entire cabinet can be used individually or in combination.
The basic cabinet interior is easy to clean and maintain.
Drawer module sizes and quantities can be adjusted according to different storage requirements. The drawers can be disassembled without additional tools; the drawer panels are equipped with sound-absorbing material. The front top panel is interlocked and stacked with the rear panel to prevent dust from entering the cabinet.
Glass door cabinets can be glass-replaced without damaging the original door structure.
Basic cabinet width450mmSingle door with a single drawer, no vertical支柱 in the center of the bottom cabinet.
Base cabinet height: 800mmHeight is measured from seat height.
Pipe from ground, walls, or service poles from the ceiling to the central console are used to conceal water, electricity, and gas pipelines.
Accessories:
Kickplate100mmHigh, deep iron gray.
Pull Handle304UType stainless steel.
2. Basic cabinet material
Basic cabinet body1.0mmHeavy galvanized steel plate, with the countertop selected based on the experimental content and the requirements of the laboratory experts. Currently using chemical and physical board countertops.
Each panel thickness meets or exceeds the following standards:
Drawer body and panel, cabinet frame, door lining, panel, bracket, safety door, and slanted countertop:1.0mm
Paneling, back panel, component top and bottom plates, component structure board, door panel, bottom cabinet back panel, vertical backers:1.0mm。
3. Hardware accessories
Handle: U-shaped 304 stainless steel handle.
Hinge:115-degree DTC hinge.
Shelf pin1.5mm thick stainless steel sheet formed by CNC punching mold (standard without layer board, optional).
Perforated holes: Laser-cut for one-time molding
Adjustable Foot:10mmGalvanized screws with a waterproof nylon circular ring as a base, allowing for easy adjustment.
4. Basins, drainpipes, and elbows
PPSink:Integrated casting, submersible installation on the surface, edge lower than the surface, connected with elbow.
Basin dimensions: (500x400X300mm)。
Elbow40mmAnti-siphon, made of polypropylene material. Elbow is easy to remove and install.
5. Other Laboratory Accessories
Faucet is a countertop-mounted type with three cold water outlets.
The faucet has a chrome-plated surface.
Easily disassemble and install pipe mouth nozzles without separating from the internal piping.
The faucet can rotate.
The faucet handles are color-coded for different purposes.
