1． Design complies with the following specifications::
Cabinet meetsSEFA Relevant standards, and throughSEFAProposed inspections for load-bearing, impact resistance, and chemical corrosion, etc.
Note:Scientific Equipment and Furniture Association (SEFA) American Association of Scientific Laboratory Equipment and Furniture
The basic cabinets are all made of full steel, pre-formed, and pre-opened structures. The intersection angle planes are smooth in both vertical and horizontal directions, without any overlapping or cracking. The door and drawer panels are on the same plane, and the interior of the panels contains sound-absorbing material.
The basic cabinet is an independent, detachable structure. The entire cabinet can be used either individually or in combination.
The basic cabinet interior is easy to clean and maintain.
Drawer module sizes and quantities can be adjusted according to different storage needs. Drawers can be disassembled without additional tools; the drawer panels are lined with sound-absorbing material. The top front panel is interlocked and overlapped with the rear panel to prevent dust from entering the cabinet.
Glass door cabinets can be refitted with new glass without damaging the original door structure.
The basic cabinet width is450mmSingle door with a single drawer, no vertical支柱 in the middle of the base cabinet.
Base cabinet height: 800mmHeight is measured from seat height.
Holes or service columns from the ceiling to the central desk, as well as those预留 in the ground or walls, are used to conceal water, electrical, and gas pipelines.
Accessories:
Skirt board100mmHigh, deep iron gray.
Handle304UFont type stainless steel.
2. Basic cabinet material
Basic cabinet body1.0mmHeavy galvanized steel plate, and select the countertop based on the experimental content and the requirements of the laboratory experts. Currently, chemical and physical board countertops.
Each panel thickness meets or exceeds the following standards:
Drawer body and panels, cabinet frames, door linings, panels, brackets, safety doors, and slanting countertops:1.0mm
Panel, Rear Panel, Component Top and Bottom Plates, Component Structure Board, Outer Door Panel, Rear Panel of Bottom Cabinet, Vertical Liners:1.0mm。
3. Hardware accessories
Handle: U-shaped 304 stainless steel handle.
Hinge:115-degree DTC hinge.
Decking Sales1.5mm thick stainless steel plate formed by CNC punch press mold (laminated board standard not included, optional).
Perforated holes: laser-cut for one-time forming
Adjustable Foot:10mmGalvanized screws, with a waterproof nylon circular collar for easy adjustment.
4. Basins, drainpipes, and elbows
PPSink:Integrated casting, submersible installation on the surface, edges below the surface, connected with elbows.
Bowl dimensions: (500x400X300mm)。
Elbow40mmAnti-siphon, made of polypropylene material. Elbow is easy to remove and install.
5. Other Lab Accessories
Faucet is a countertop-mounted type with three cold water outlets.
The faucet features a chrome-plated finish.
Easily detach and install pipe mouth nozzles without separating from the internal piping.
The faucet can rotate.
The faucet handles are color-coded to indicate different uses.
