When producing polymer putty in large quantities, an appropriate amount of cement can be taken from the packaging drum. It is recommended to roll it into strips or press it into strips using a mold, then cut into small pieces to ensure quality consistency. At this point, shape it into the desired form and fill or apply it to the corresponding area. Another method is to pre-make molds, extract the appropriate amount, compact it in the mold, and scrape off the excess thermal grease with a knife. Then, fill each piece according to the need. It's important to note that the requirements for the hardness and viscosity of polymer putty may vary in different applications. A very special method of use is pneumatic dot glue extrusion. This should be packaged in an EFD syringe. Of course, this makes it much easier for users of polymer putty, as they not only need to be able to produce according to the formula but also control the hardness and viscosity throughout the process.