Seismic-resistant/pipe gallery/support production equipment (optional online punching and forming model for one-step completion)

Equipment Composition

Forming Line: Coil loading and uncoiling ---- leveling and feeding integrated machine ---- forming main unit (gear cutting, marking) --- alignment device ---- cutting system ---- collection table. Electrical control utilizes PLC programmable logic control.

Piercing line: Workbench - Pneumatic fixture, Servo feeding device ---- Hydraulic (press brake) piercing

Electrical control uses PLC programmable logic control

Hole punching method, based on actual circumstances and considering various factors, is done after forming.

Customizable all-in-one punching and forming production line (punching first, then forming)

Equipment Technical Conditions:

1. Equipment Floor Space: 30×3.5×5 meters (Length×Width×Height)

1.2 Equipment Feed Direction: TBA.

1.3 Voltage Parameters: 380V, 50Hz, 3-phase.

1.4 Gas Source: Flow rate of 0.5 m³/min; Pressure of 0.6 MPa.

1.5 Hydraulic Oil: 46# Hydraulic Oil.

1.6 Gear Oil: 18# Hyperbolic Gear Oil.

2 Main Technical Parameters of the Equipment

2.1 Rolling Strip Width: ≤300 mm

2.2 Rolling Strip Thickness: 2.0~2.5mm (Standard)

2.3 Rolling Strip Material: Q235

2.4 Production Speed: Host machine continuous molding speed 0-15 meters/minute

2.4 Rolling workpiece length: 2000-6000 mm

2.5 Total Equipment Installation Capacity: Approximately 50 kW.

2.6 Gear Depth: ≥1.0mm