Seismic-resistant / Tunnel / Bracket Manufacturing Equipment

Equipment Composition

Forming Line: Coiling material uncoiling ---- Leveling and feeding integrated machine ---- Forming main unit (ratchet, marking) --- Calibration device --- Cutting system --- Receiving table; Electrical control utilizes PLC programmable logic control

Punching Wire: Bench ---- Pneumatic Clamping, Servo Feeding Device ---- Hydraulic (Press Brake) Punching

Electrical control utilizes PLC programmable logic control

Punching method: Based on actual circumstances and considering various factors, the formed product is used.

Customizable into a one-step punching and forming production line

Equipment Technical Conditions:

1. Equipment footprint: 30 x 3.5 x 5 (Length x Width x Height) meters.

1.2 Equipment Material Direction: To be determined.

1.3 Voltage parameters: 380V, 50Hz, 3-phase.

1.4 Gas Source: Flow rate of 0.5 m³/min; pressure of 0.6 MPa.

1.5 Hydraulic Oil: 46# Hydraulic Oil.

1.6 Gear Oil: 18# Hypoid Gear Oil

2 Main Technical Parameters of the Equipment

2.1 Rolling Strip Width: ≤300 mm

2.2 Rolling Strip Thickness: 2.0~2.5mm (Standard)

2.3 Rolling Strip Material: Q235

2.4 Production Speed: Continuous molding speed of the main unit is 0-15 meters per minute.

2.4 Rolling workpiece length: 2000-6000 mm

2.5 Total installed equipment capacity: approximately 50KW.

2.6 Gear Depth: ≥1.0mm